1964 Corvette: Service News: Corvette Hood Support Safety Hole

Subject: Corvette Hood Support Safety Hole
Model and Year: 1964 Corvette
Source: Chevrolet Service News
Page Number:   1
Date: January 1964, Volume 36, Number 1

Some early 1964 Corvettes have been built with the hood support safety hole through only one side of the hood support.  This problem is easily corrected.  First, raise the hood until it locks in the open position; then drill the 19/64" safety hole using the hole in the support lower half as a guide.

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
There are no comments for this article. Be the first to post a comment.
Security Code Security Code