GM plans to move new Camaro production from Canada to Michigan
GM plans to move new Camaro production from Canada to Mich.
Vince Bond Jr.
Automotive News -- December 19, 2012 - 12:19 pm ET
General Motors plans to move production of the next-generation Chevrolet Camaro to Michigan from Canada.
The Camaro, currently made in Oshawa, Ontario, will be built at the Lansing Grand River Assembly Plant in Lansing, Mich., GM said today in a statement.
The automaker cited “lower capital investment” and “improved production efficiencies” as reasons for the shift.
Moving Camaro duties to the Grand River plant allows GM to consolidate production of the rear-wheel-drive sports car with the rwd Cadillac CTS and ATS. The Camaro was the only rwd vehicle assembled at the Oshawa plant, GM said.
Read more: http://www.autonews.com/article/2012...#ixzz2FWjtJRau
Sorry to everyone up around Oshawa, but Lansing can use the jobs!!!
Originally Posted by tankman
GM Oshawa Gone?
As of now, GM Oshawa has nothing at all on the books to build after 2016. Could be the end of the Oshawa complex. The 3+ million square foot truck plant shut down production a few years ago. It's not looking good for Oshawa right now.
By Rob in forum News and Announcements Forum
Last Post: 09-15-10, 06:47 PM
By catbert in forum Bowling Green Assembly Plant / National Corvette Museum News
Last Post: 08-27-10, 12:33 PM
By Rob in forum C7 General Discussion
Last Post: 09-30-07, 07:44 PM
Tags for this Thread
Owned and Operated by © 2000-2015 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved