Corvette Action Center - The ultimate online hub of Corvette news and information!
Supporting Vendors / Dealers - Supporting Membership - Advertising Information - Corvette Amazon Shop

Results 1 to 4 of 4

Thread: broken grease zerk on lower balljoint

  1. #1

    Default broken grease zerk on lower balljoint

    Just had an oil change and lube and was informed i had a broken grease zerk on the lower ball joint of passenger side. was told that the balljoint would have to be replaced because of the broken zerk. does anyone know if i can replace the zerk? i know most of them are threaded. thanks joe

  2. #2
    Member 68Roadster's Avatar
    Join Date
    Dec 2002
    Dallas, TX
    Post Thanks / Like
    '68 White Vert '05 Silverado SS


    Having to replace the ball joint is the last option.

    These fittings are threaded but they can be removed by using an easy-out, available on the Snap-On truck/catalog, local parts stores, etc.
    I have also heard of people trying left hand twist drill bits to remove broken fasteners.
    You could also drill this thing out to almost the exact size of the threads and collapse the remaining portion of the fitting and remove it that way.
    We used to do all these techniques on our airplanes in lieu of actually replacing a major portion of the landing gear. In your case, replacing a ball joint, and getting an alignment done afterwards.
    Sonds like someone is trying to get more out of you than actually needed. If you don't feel like doing it yourself, get someone at the local machine shop. These guys get busted off bolts out of blocks for a living, along with the other magic they perform.

    My .02 worth.


  3. #3
    Member jmccloud's Avatar
    Join Date
    Feb 2003
    Post Thanks / Like
    1995 White Coupe LT-1 Auto

    Default Zerks

    A tractor store will have a zerk extractor (easy out) and new zerk for very low price (extractor and 10 various size zerks for $10 or so). Most auto stores too. Use the tapered thread type, not the drive type.
    Replace the zerk, cleaning out the hole before putting in the new one, and make sure the joint takes grease. If not, the ball joint itself is likely damaged (usually not).
    Good luck,

  4. #4


    thank you guys. we replaced the fitting easily. its great to be a do it yourselfer at times. joe

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division.  Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for content, comments, or advertising. is independent from GM© and is not affiliated with, sponsored or supported by GM©.  Copyright/trademark/sales mark infringements are not intended, or implied.  All Rights Reserved