info about any headers that fit angle plug aluminum heads ZZ4,auto trans.84 vette,thanks.
looking @ hooker for now.
I had to 'dimple' mine and then use ceramic spark plug boots. Any other boots, including the pricey heat resistant sleeves, burned in short order.
409 cid four bolt, forged crank/11:1/alum. Dart Pro-1/FMS-30pph@45 psi/BBK 52mm/'90 ECM Custom chip/Lingenfelter SuperRam/Comp Cams hydr. roller 230i-236e@050 /TPIS long tubes 3"/'84 Corvette cat/Flowmasters/ BeCool rad./FlowTech water pump/180* 'stat/3.54:1 rear gears +case cryo hardened/Bilsteins: 'Challenge' specs/Heim jointed rear suspension; all poly/ZF6-40 by ZF Doc//I.M.I. mini-starter/Battery inside/Electric HydroBoost brakes/FatMatted/Shinoda body/updated PwrWindows
By SIXTYTWO in forum C3 Parts For Sale / Wanted
Last Post: 02-04-08, 04:46 PM
By corvette66 in forum C3 Technical and Performance
Last Post: 03-21-07, 12:04 AM
By vette-dude in forum C4 Technical and Performance
Last Post: 09-24-04, 02:26 PM
By MaineShark in forum C3 Technical and Performance
Last Post: 03-11-03, 07:54 AM
By KTM in forum General Automotive Discussion
Last Post: 06-27-02, 01:16 AM
Owned and Operated by © 2000-2015 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved