-
Fanman
Is it good practice to use an electrical grease in the plug in connectors on C-2corvettes?
-
Site Administrator

Originally Posted by
FANMAN
Is it good practice to use an electrical grease in the plug in connectors on C-2corvettes?
Welcome to the Corvette Action Center. Moving to the C1/C2 forum...
-

Originally Posted by
FANMAN
Is it good practice to use an electrical grease in the plug in connectors on C-2corvettes?
Yes, it is - using a film of dielectric grease (available at Radio Shack) on the terminals in the two 8-way multiple connectors on the engine side of the fuse block will protect them from corrosion, which is a chronic C2 issue.
-
Dielectric grease
Thank you for the information!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Owned and Operated by © 2000-2013 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved
Bookmarks