Rear end gear question?
A friend of mine has a 67 BB with 3:57 ring and pinion gears. The question he's asking is, will a 4:11 ring and pinion gear set bolt into the 3:57 differential housing? Any help would be appreciated. 84 CF 91 ZR-1
Stingray6974 is our resident gear expert. He should know for sure.
Yup, the 4.11's will fit in the diff housing, but he'll have to buy a new Series 4 carrier (Posi case) for that ring & pinion, as the lateral offset is different.
Thanks for the info C-2 guys. He made a decision to go with 3:90 gears. A Richmond 6 speed currently resides in his 67 so he should be fine with the 3:90 gears, again thanks. 84 CF 91 ZR-1
Owned and Operated by © 2000-2015 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved