$projecthp

Search:

Type: Posts; User: GWinter; Keyword(s):

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    10
    Views
    718

    Help! those numbers flashing all over the place, those...

    those numbers flashing all over the place, those temp? if so something wrong in the temp circuit , could be ground, I belive there is a group of ground wires on one of the bell housing bolts fun to...
  2. Replies
    1
    Views
    288

    Others may have diff views on this,but I would...

    Others may have diff views on this,but I would stay with the 10W40 . I believe the manual calls for 5w30 I run 10w30 in my 90 with 106,000 miles . Summer temps range from 50 to close to 100 and I...
  3. Replies
    10
    Views
    718

    Help! Clean ALL grounds. Some of what you said...

    Clean ALL grounds. Some of what you said pointed to electrical. Poor grounds on these corvettes cause strange problems.If that don't cure most of the problems have the alternator checked.Also it...
  4. If your going to be working on the care more...

    If your going to be working on the care more often you should order the factory service manual.
  5. Replies
    6
    Views
    543

    how good is your battery bad one can cause all...

    how good is your battery bad one can cause all kinds of strange problems.
  6. Replies
    13
    Views
    844

    did you replace the ignition module in the...

    did you replace the ignition module in the distributor ?
  7. Replies
    10
    Views
    925

    Does it get wet just standing or do you need to...

    Does it get wet just standing or do you need to be moving for it to get wet. My 90 the windshield seal leaks at the bottom and in rain the water blows under the windshield. I have tried injecting...
  8. did you take the slave cyl lose and tilt it to...

    did you take the slave cyl lose and tilt it to bleed? the way they are mounted the bleed screw is usually at the lower end which traps air . would think you cam across this in your searches.
    just...
  9. Replies
    1
    Views
    689

    Sounds like it may be low on Freon. I would hook...

    Sounds like it may be low on Freon. I would hook up a set of gauges and check that first.Something you could try ,locate
    the low pressure switch and jumper the two wires to see if it runs, if it...
  10. Replies
    6
    Views
    2,133

    The engine will most likely overheat without a...

    The engine will most likely overheat without a thermostat , coolant moves to fast to transfer heat.
  11. Replies
    7
    Views
    2,168

    Was the flywheel replaced or just the clutch...

    Was the flywheel replaced or just the clutch disk. OEM was a dual mass flywheel which has lube in it. If it wasn't replaced (they are not available need to replace with standard flywheel/clutch) you...
  12. Replies
    4
    Views
    1,698

    You say the cooling fan was wired to ignition.....

    You say the cooling fan was wired to ignition.. Generally the cooling fans run on relays, relays are wired with coil to 12 v. the relay ground is completed by the ECM to turn on the fans. I would...
  13. Replies
    2
    Views
    1,623

    Help! GM tachs in Camero and Corvette around that time...

    GM tachs in Camero and Corvette around that time period are known to go bad. There are youtubes on how to repair them . If you can't repair it you need to remove the cluster and replace it or have it...
  14. Replies
    3
    Views
    1,834

    I have the OBD I cable on that site, works well I...

    I have the OBD I cable on that site, works well I downloaded some software from the place they listed . The software also works well.
  15. If the car hadn't been moved in a few weeks and...

    If the car hadn't been moved in a few weeks and the tires are a soft compound they could have flat spots which could make it shake badly. Would have to get some heat in the tires to get them to...
  16. Replies
    12
    Views
    2,692

    I don't like what you describe ,my 90 is one of...

    I don't like what you describe ,my 90 is one of the best braking cars I have ever had. I wonder it there is air in the system or the master cyl isn't in the best shape. I use heavy toe pressure to...
  17. Thread: C4 Mufflers

    by GWinter
    Replies
    13
    Views
    3,344

    Do not install a larger pipe from the cat back. I...

    Do not install a larger pipe from the cat back. I installed 3 in OD pipes on my 90 from the cat back and without real loud mufflers I have a terrible drone at highway speed . I attribute it to the...
  18. Replies
    3
    Views
    1,383

    Important! now that DonB mentioned it , yes multiple fuses...

    now that DonB mentioned it , yes multiple fuses contribute. Check every fuse.
  19. Replies
    7
    Views
    1,499

    are you sure your hearing the starter click or...

    are you sure your hearing the starter click or just the relay. The relay may be bad ,
  20. Replies
    9
    Views
    2,232

    Are you suggesting replacing the 90 with a later...

    Are you suggesting replacing the 90 with a later exhaust ?
  21. Replies
    2
    Views
    1,788

    I am not really big on snake oil stuff but before...

    I am not really big on snake oil stuff but before you replace it pick up a bottle of Lucas power steering additive. I had the growling and morning sickness. I put in a bottle of the Lucas and almost...
  22. Replies
    11
    Views
    1,894

    Help! If I remember right the fans run when you jumper...

    If I remember right the fans run when you jumper the OBD port to get codes, you didn't by chance leave a jumper on ? Maybe not applicable to OBDII which started showing up in 95
  23. Replies
    11
    Views
    1,894

    Help! If the air is on both fans should run. Turn the...

    If the air is on both fans should run. Turn the air of if it is on. Wasn't a switch added by previous owner that you turned it on unknowingly ?
  24. No code ? I would check temp sensor and TPS

    No code ? I would check temp sensor and TPS
  25. Thread: Crazy Tach!

    by GWinter
    Replies
    6
    Views
    1,295

    I don't use my radio/stereo enough to even know...

    I don't use my radio/stereo enough to even know for sure if it works. lol But I am going to look for missing screws , cracks and places where I can insulate to get rid of dash noise.
Results 1 to 25 of 30
Page 1 of 2 1 2