Search:

Type: Posts; User: ecss; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    2
    Views
    1,660

    Turn the Parking or Headlights on and rotate the...

    Turn the Parking or Headlights on and rotate the headlight dimmer switch and see if you can read the LCD better.
    If not, could be the backlight bulbs are burnt out or the LCD needs to be replaced. ...
  2. Replies
    4
    Views
    1,604

    The 90 owners manual mentions the Delco Loc anti...

    The 90 owners manual mentions the Delco Loc anti theft feature for the Bose Gold radio. I don't see it mentioned in the 94 owners manual. I was under the impression all Bose Gold 90-96 were the same...
  3. Thread: Horns

    by ecss
    Replies
    14
    Views
    2,702

    Well it appears 90 to at least 93 the contacts...

    Well it appears 90 to at least 93 the contacts were part of the button.
    In 94-96 they used separate button and switches.

    Reproduction buttons are on E-bay.

    Here's a link showing the guy pried...
  4. Thread: Horns

    by ecss
    Replies
    14
    Views
    2,702

    I dont' know what the difference is between 90-96...

    I dont' know what the difference is between 90-96 horn switches but Corvettecentral.com lists horn switches for 94-96 for the bargain price of $69.95 plus shipping. Not sure if that is for one or two...
  5. Thread: Horns

    by ecss
    Replies
    14
    Views
    2,702

    If the steering wheel horn switches don't work...

    If the steering wheel horn switches don't work you need to remove the air bag.

    Disconnect the negative battery cable and wait about 30 minutes.

    Use a 30mm torx bit and remove the two torx...
  6. Thread: Horns

    by ecss
    Replies
    14
    Views
    2,702

    There are two ways the horns can be enabled. 1)...

    There are two ways the horns can be enabled.
    1) By the steering wheel horn buttons. (Which do go bad/crumble on a 91).
    2) The Central Control Module which controls the factory alarm.

    When the...
  7. Replies
    3
    Views
    1,321

    Question: If your engine temps were in the normal range and...

    If your engine temps were in the normal range and not over 230F I doubt the heat from the transmission tunnel caused the engine to stall.

    To see the digital coolant read out, keep pressing the...
  8. Replies
    6
    Views
    3,728

    When you use one of the hatch release switches...

    When you use one of the hatch release switches can you hear that relay you replaced make a click?

    If you do hear a click the problem is usually a bad ground connection inside the hatch release...
  9. Replies
    7
    Views
    1,446

    You need to measure the voltage on the Purple...

    You need to measure the voltage on the Purple wire at the starter when the problem occurs.

    You don't mention if you have a manual or automatic transmission.

    For an automatic try starting in...
  10. Replies
    6
    Views
    3,728

    Reach under the rear cover shade and pull the...

    Reach under the rear cover shade and pull the carpet down around the latch area. You should see a short metal pull cable. Tug on that and the latch should release allowing the hatch to open.
    ...
  11. Thread: Horns

    by ecss
    Replies
    14
    Views
    2,702

    You need to clean the two prongs with the yellow...

    You need to clean the two prongs with the yellow arrows pointing to them.
    You also need to clean the contact area the two prongs make when the horn button is pushed down.
    That grounds the Yellow...
  12. Replies
    1
    Views
    2,940

    Replacement part $50-$90. I would use an AC Delco...

    Replacement part $50-$90. I would use an AC Delco part.

    The sensor is held in place by one 8mm bolt and is bolted to the bottom passenger side of the timing cover.
    ...
  13. Thread: clicking sound

    by ecss
    Replies
    3
    Views
    1,366

    Help! Until the battery cables are completely tight the...

    Until the battery cables are completely tight the lights will flicker and the headlight motors will make a clicking sound as they are driven to the closed position by the headlight control module....
  14. Thread: 1994 zr1 405 6spd

    by ecss
    Replies
    3
    Views
    2,950

    Help! http://i135.photobucket.com/albums/q129/88f150xlt/...

    http://i135.photobucket.com/albums/q129/88f150xlt/seal_zps2fyufkne.jpg

    http://i135.photobucket.com/albums/q129/88f150xlt/seal%201_zps811dudnx.jpg
  15. Replies
    3
    Views
    2,626

    Question: SYS indicates the CCM has stored a trouble code....

    SYS indicates the CCM has stored a trouble code.
    Take a piece of wire or paper clip and connect Pin A to Pin G on the diagnostic connector located above
    the drivers right knee.

    Turn the ignition...
  16. Thread: Ride control

    by ecss
    Replies
    7
    Views
    2,284

    On the diagnostic connector located above the...

    On the diagnostic connector located above the drivers right knee area, use a piece of wire or paper clip
    and connect Pin A to Pin C.

    Turn the ignition On. Do not start the car.

    The Service...
  17. Replies
    23
    Views
    4,135

    Help! Any signs of rodents have been under the hood or...

    Any signs of rodents have been under the hood or in the interior of the car?

    More likely the fuel injectors are not being pulsed by the ECM.

    If you rent a noid light you unplug one of the fuel...
  18. Thread: fuel delivery

    by ecss
    Replies
    5
    Views
    1,770

    Help! The fuel pump only runs for 2 seconds when you...

    The fuel pump only runs for 2 seconds when you turn the ignition on.
    The fuel pump runs continuously if there are distributor reference pulses indicating the engine is rotating.

    Have you tried...
  19. Thread: fuel delivery

    by ecss
    Replies
    5
    Views
    1,770

    Help! On the rear of the passenger side fuel rail is a...

    On the rear of the passenger side fuel rail is a schrader valve. There maybe a screw on cap like a
    tire valve stem.

    Crank the engine for a few secondes.
    Remove the cap if there is one. Press...
  20. Thread: 1994 Corvette

    by ecss
    Replies
    1
    Views
    1,179

    Question: The most common problem if the air doesn't come...

    The most common problem if the air doesn't come out of the correct vents is the vacuum check valve located under the passenger side engine black plastic fuel rail cover is bad.

    Looks like this.
    ...
  21. Thread: Brakes

    by ecss
    Replies
    10
    Views
    1,642

    Watch these two videos. Corvette C4 Front...

    Watch these two videos.

    Corvette C4 Front Brakes **PART 1** - Easy fix! - YouTube
    Corvette C4 Front Brakes **PART 2** -Easy fix- - YouTube
  22. Replies
    8
    Views
    2,676

    The temperature of the ECT sensor can be...

    The temperature of the ECT sensor can be displayed on the dash cluster by repeatedly pressing the Gauges button until you see coolant displayed.

    If you monitor that display the primary fan should...
  23. Very rare for a 93 HVAC programmer to cause a...

    Very rare for a 93 HVAC programmer to cause a problem.
    If the air is coming from the wrong vents the vacuum check valve is usually the problem.
    Does the cruise control work? It shares the same...
  24. Replies
    8
    Views
    2,676

    You need to be provide more information. Is...

    You need to be provide more information.

    Is this a new problem?

    Why do you say the fans don't work is the engine over heating?

    Be more specific on how you tested the fan relays relays.
    ...
  25. Replies
    8
    Views
    2,676

    The fans are controlled by the ECM. The Primary...

    The fans are controlled by the ECM.
    The Primary fan comes on around 226F and the Secondary at around 235F.
    To verify the fans can be controlled by the ECM.
    Take a piece of wire and connect pin A...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4