$projecthp

Search:

Type: Posts; User: Midnight 99; Keyword(s):

Page 1 of 5 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    6
    Views
    254

    Have you checked your fuel pressure? Your fuel...

    Have you checked your fuel pressure? Your fuel pump could be overheating and cutting out until it cools and starts to pump again. Just a thought.
  2. Replies
    2
    Views
    1,703

    Help! Once you have the steering wheel locking ring...

    Once you have the steering wheel locking ring removed you need to remove the signal indicator handle and then the signal switch. Insert the key in the lock and turn it to the On position. Looking...
  3. Replies
    2
    Views
    1,173

    You can use a 5 blade fan with the fan clutch. ...

    You can use a 5 blade fan with the fan clutch. It will help pull more air through the radiator. You could also install an electric pusher fan in front of the radiator to increase air flow. That...
  4. Replies
    400
    Views
    135,345

    Notice: Our Torch Red 13 GS 3LT MZ6 convertible.

    Our Torch Red 13 GS 3LT MZ6 convertible.
  5. Replies
    5
    Views
    1,284

    You may be able to rotate it enough to make you a...

    You may be able to rotate it enough to make you a little more comfortable. Good Luck and welcome back to Corvette ownership.
  6. Replies
    5
    Views
    1,284

    Unless it sits all the way at the bottom of the...

    Unless it sits all the way at the bottom of the engine bay or you decide to foolishly drive through deep water you should be fine. Personally I would replace it with a Blackwing style system.
  7. Replies
    226
    Views
    28,623

    In addition to the 13 GS convertible, a 69...

    In addition to the 13 GS convertible, a 69 Camaro, 71 Nova and a 2014 Malibu for a DD.


    21456
  8. Replies
    17
    Views
    5,955

    Question: I had the GY's on my 13 GS Convertible replaced...

    I had the GY's on my 13 GS Convertible replaced last week with Bridgestone Potenza RFT's. $1,736.00 mounted, balanced and sales tax. The difference in the ride and noise is like night and day.
  9. Replies
    3
    Views
    1,515

    It can not help you with your VIN for the 68 but...

    It can not help you with your VIN for the 68 but it is true that you get a one year free membership to the museum when you are the original purchaser of a new Corvette.
  10. Replies
    17
    Views
    5,955

    Question: If the price is right, buy the car. You should...

    If the price is right, buy the car. You should get around 15,000 miles from the GY's. My 13 GS has 15,000 miles on it and I still have sufficient tread for another 2,000 miles. Many owners replace...
  11. Replies
    2
    Views
    1,397

    In 2013 we toured Ken's collection as one of the...

    In 2013 we toured Ken's collection as one of the opening events for the Hot Rod Power Tour. He has some awesome rides. Ken is a great guy. I highly recommend attending his event.
  12. Ditto. No need to change the pushrods unless...

    Ditto. No need to change the pushrods unless you go to a different ratio rocker arm.
  13. Replies
    10
    Views
    1,834

    I agree. Since you are not doing an NCRS...

    I agree. Since you are not doing an NCRS restoration, remove the wiper door and the cowl grille and replace your hood with a Long Style L88 hood. There are several vendors that carry them. Problem...
  14. Replies
    8
    Views
    4,942

    As Peter said place the jack under the front edge...

    As Peter said place the jack under the front edge of the cross member. I have been doing that for more than 40 years and have never dented one. Sorry I was not that explicit with my first...
  15. Replies
    5
    Views
    3,569

    Question: The rubber is breaking down. The only solution I...

    The rubber is breaking down. The only solution I am aware of is a replacement steering wheel.
  16. Replies
    8
    Views
    4,942

    If you just want to raise the front end you can...

    If you just want to raise the front end you can use the crossmember. Just make sure the jack is centered and always use jack stands. I have used the center of the frame rails under the door to lift...
  17. Replies
    8
    Views
    7,301

    Welcome to CAC Glenn. There are 2010 GS drop...

    Welcome to CAC Glenn. There are 2010 GS drop tops out there. A friend of mine found an 11 3LT back in January for a very reasonable price. Good Luck and hope you find the ride that pleases you!!!
  18. Replies
    10
    Views
    2,166

    It is possible that there was a chunk of rust...

    It is possible that there was a chunk of rust that broke loose in the fuel line, clogging the carb and starving it.
  19. Thread: Alignment

    by Midnight 99
    Replies
    6
    Views
    2,014

    Absolutely get a 4 wheel alignment on any...

    Absolutely get a 4 wheel alignment on any Corvette after 1962. The rear toe and camber are just as important as the front. I had a 4 wheel alignment done once a year on my 69, 99 and now my 13 GS.
  20. Replies
    3
    Views
    1,108

    The actuator arm for the fuel pump operates from...

    The actuator arm for the fuel pump operates from the front lobe on the cam. It will catch on the next lobe when you try to remove the cam. Please be very careful removing the cam so you do not drag...
  21. Replies
    7
    Views
    2,685

    Question: If you know anyone in the moving business you...

    If you know anyone in the moving business you could borrow four furniture dollies and place them under the frame in front of and behind the doors.
  22. Replies
    22
    Views
    4,067

    Ditto on the crescent wrench.

    Ditto on the crescent wrench.
  23. Question: The extensions on the gasket should be pushed in....

    The extensions on the gasket should be pushed in. If you have any appreciable brake fluid loss it allows for the centers to pull down so there is some give so the gasket does not pull in from around...
  24. Replies
    22
    Views
    4,067

    Definitely change the differential fluid. Glad...

    Definitely change the differential fluid. Glad to hear your bearings were not the problem. I replaced mine when I was doing the ground up on my 69. The trailing arms can be a bear to remove and...
  25. Replies
    21
    Views
    3,341

    Have you checked the ignition module? I had the...

    Have you checked the ignition module? I had the same issues with my 94 Z28 and found the module was bad. The module for the Camaro was riveted to the coil bracket. I can't say where it is on the...
Results 1 to 25 of 118
Page 1 of 5 1 2 3 4