$projecthp

Search:

Type: Posts; User: LLC5; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Thread: Electrical

    by LLC5
    Replies
    8
    Views
    180

    Lots of moons have passed since I worked on that...

    Lots of moons have passed since I worked on that vintage a vehicle, but I believe that is proper function.

    Can you post a picture of your HVAC control faceplate with all the modes and blower...
  2. Thread: Electrical

    by LLC5
    Replies
    8
    Views
    180

    It sounds like the ground for your gauge assembly...

    It sounds like the ground for your gauge assembly is missing, check all your wire connectors and pins on the gauge assembly.
  3. Replies
    10
    Views
    263

    It's possible that the pin connector for the...

    It's possible that the pin connector for the blower motor, where it comes through the metal base, was touching the body of the blower motor with the harness connected.
  4. Replies
    3
    Views
    142

    Good info. Always keep the fuse as close as...

    Good info.

    Always keep the fuse as close as possible to the battery source.
  5. Replies
    3
    Views
    142

    Holy hell, absolutely no scotch locks. Ever. ...

    Holy hell, absolutely no scotch locks. Ever.

    You should use a 30A rated relay to power your water pump. Solder and heat shrink all wire connectors or use quality tape and pull it tight.

    Do...
  6. Replies
    9
    Views
    230

    Beats the hell out of lithium batteries for sure....

    Beats the hell out of lithium batteries for sure.

    Enjoy the ride.
  7. Replies
    8
    Views
    192

    Good to have you.

    Good to have you.
  8. Replies
    10
    Views
    263

    Just make sure that the two separate wires aren't...

    Just make sure that the two separate wires aren't plugged on backwards.
  9. Replies
    10
    Views
    263

    Yes, but I would remove it first and turn it by...

    Yes, but I would remove it first and turn it by hand to see if it moves freely.

    Does the blower motor have 2 wires or one wire going directly in to it?
  10. Replies
    10
    Views
    263

    FYI, do NOT install a larger fuse than...

    FYI, do NOT install a larger fuse than recommended by the vehicle.
  11. Replies
    10
    Views
    263

    Unplug the blower motor connections and see if...

    Unplug the blower motor connections and see if the short disappears.
  12. Thread: Fng

    by LLC5
    Replies
    15
    Views
    532

    Welcome FNG... Always gotta start...

    Welcome FNG...

    Always gotta start somewhere....:)
  13. Help! Ok, I wasn't what sure what year GM switched to...

    Ok, I wasn't what sure what year GM switched to grounding the field circuit of the motor windings through the switches.

    Good info.
  14. Help! Diagnosis is in order first. Find out what you...

    Diagnosis is in order first. Find out what you are missing at the motor, battery positive or battery negative. I believe your master switch grounds one side of the circuit in the neutral position,...
  15. Drive it for fun. Keep the expenses low.

    Drive it for fun. Keep the expenses low.
  16. Hopefully that hardtop is one strong unit with...

    Hopefully that hardtop is one strong unit with matching exterior covering, it is going to get very hot, even with the vents.
  17. Replies
    1
    Views
    170

    I suppose that it could be, check it with...

    I suppose that it could be, check it with compressed air.
  18. Replies
    2
    Views
    198

    Help! No, the left sensor is in the left side exhaust...

    No, the left sensor is in the left side exhaust and the right side is in the right side exhaust. However, the wire harness connectors cross over the pipes and are on the opposite sides, NOT the...
  19. Replies
    3
    Views
    318

    Not likely unless it burned some wires or vacuum...

    Not likely unless it burned some wires or vacuum hoses.
  20. Replies
    1
    Views
    181

    Yes some OEM harmonic balancers have a very...

    Yes some OEM harmonic balancers have a very slight wobble at hot idle.
  21. Replies
    1
    Views
    435

    Want some better advice? Don't use an icon or...

    Want some better advice? Don't use an icon or "heart" to buy parts.

    Do some research with your VIN number and get the correct part. Your local dealership can help by giving you the correct part...
  22. The Unions always want more to justify their...

    The Unions always want more to justify their existence.

    Why workers vote down a pay raise is beyond me.
  23. Replies
    6
    Views
    483

    What do you mean by sticky clutch? After itís hot...

    What do you mean by sticky clutch? After itís hot and a high rpm run over 4-5000 rpms or all the time?
  24. Replies
    1
    Views
    310

    Help! Got any pictures?

    Got any pictures?
  25. Replies
    3
    Views
    591

    Nice. I'll take the black one.

    Nice. I'll take the black one.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4