$projecthp

Search:

Type: Posts; User: Hib Halverson; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.09 seconds.

  1. Replies
    2
    Views
    154

    As you know, you have two faults, one in the MAF...

    As you know, you have two faults, one in the MAF sensor circuits and one in the burn-off relay circuits. The diagnostic info for those two faults is too lengthy to repost here.

    Do you have the...
  2. Well...if Dave says it's a wrist pin, it's time...

    Well...if Dave says it's a wrist pin, it's time for an engine overhaul.

    Good luck.
  3. Replies
    1
    Views
    185

    I'd take Cardone's work on this problem before...

    I'd take Cardone's work on this problem before I'd take Summit's.

    Cardone actually rebuilds ECMs. All Summit does is sell parts.

    If you still have your '82 ECM, have you tried reinstalling it?
  4. Replies
    4
    Views
    182

    Question: You say you can see the brake slowly apply... ...

    You say you can see the brake slowly apply...

    Is that with the ignition on or off? When the caliper slowly applies, can you hear the ABS pump motor running?

    Your post was a little unclear on...
  5. Replies
    2
    Views
    116

    Do a compression test and a leakage test. That...

    Do a compression test and a leakage test. That will help you determine if the problem is valve-related.
  6. Replies
    5
    Views
    402

    Question: I'll assume from the short OP that it only shakes...

    I'll assume from the short OP that it only shakes when the car is moving.

    Have the rear tires balanced.

    I would have a service facility inspect all of the front suspension, rear suspension and...
  7. Replies
    3
    Views
    196

    Help! If a brake caliper "froze" with the brake applied...

    If a brake caliper "froze" with the brake applied you'd have noticed that right away by either that wheel locked or the car pulling. If neither of those characteristics were present, then the brake...
  8. If the engine makes "wrist pin" noise, then you...

    If the engine makes "wrist pin" noise, then you have a potentially expensive problem because, when the engine is in good condition, wrists pins don't make noise that you could hear. If in fact the...
  9. Replies
    1
    Views
    162

    There is no easy way to determine conclusively...

    There is no easy way to determine conclusively whether and engine has been "dyno tuned".

    One way to tell is to compare the current calibration in the ECM to a stock cal. You'd need HPTuners for...
  10. Replies
    3
    Views
    202

    Have you checked both ends of each cable?

    Have you checked both ends of each cable?
  11. You're getting the check gauges light because...

    You're getting the check gauges light because your gas gauge senders are FUBAR and that makes the ECM think you're running out of gas. I don't think you can "reset" the check gauges warning when it's...
  12. Replies
    4
    Views
    285

    When you say you are "plugging in" these gauges,...

    When you say you are "plugging in" these gauges, I'm trying to understand what you mean.

    Are you working underneath the instrument panel connecting the wiring harness to the gauges? Are you doing...
  13. Replies
    3
    Views
    1,003

    You're joking...right?:chuckle One of the...

    You're joking...right?:chuckle

    One of the downsides of forum sites is posts offering technical information offered by persons who have little understanding of the subject about which they are...
  14. Replies
    2
    Views
    507

    High idle is often caused by a vacuum leak. Have...

    High idle is often caused by a vacuum leak. Have you inspected the induction system beyond the throttle body for vacuum leaks?

    Do you have the '85 Service Manual.
    If not, buy one.

    There is...
  15. Replies
    3
    Views
    415

    Do you have the '01 Factory Service Manual?

    Do you have the '01 Factory Service Manual?
  16. Changing front shocks is not difficult provided...

    Changing front shocks is not difficult provided you have the proper tools.

    Unfortunately, MR shocks might be pretty pricey...if you can still get the first Gen MR shocks.
  17. Replies
    2
    Views
    435

    I don't know what some of those mean as I've...

    I don't know what some of those mean as I've never used "ALDLdroid" which I suspect is an app on an Android phone. First of all, get a real scan tester.

    What I can tell you is:

    Engine speed...
  18. Based on the OP, the problem is just as likely to...

    Based on the OP, the problem is just as likely to be with the charging system as with the battery.

    Check battery cables (both ends) for corrosion.
    Have the battery tested.
    Troubleshoot the...
  19. Replies
    3
    Views
    368

    Help! Provided the fuel system and the ignition system...

    Provided the fuel system and the ignition system are in good condition...if that engine has a camshaft more aggressive than the stock cam, I'm going to take a wild-assed guess and suggest that the...
  20. Replies
    5
    Views
    742

    Solution: Stop using a dealer for tire work. ...

    Solution:
    Stop using a dealer for tire work.

    Dealers only do tire work because the dealer community saw the money tires vendors make and wanted in on the profits. Folks like you, who want the...
  21. There are a number of small things I can see in...

    There are a number of small things I can see in the engine imagery attached to the OP that would make me a bit apprehensive.

    1) The IAT sensor installed into the air bridge with RTV.
    2) There is...
  22. Replies
    5
    Views
    742

    Michelin RFTs used on Corvettes under certain...

    Michelin RFTs used on Corvettes under certain circumstances can be repaired. As you've heard from others, it depends on where the puncture is located. Also, the speed rating goes down.

    Discount...
  23. Replies
    3
    Views
    682

    Help! Can you be a little more specific? With your...

    Can you be a little more specific?
    With your foot on the brake, can you not shift out of Park at any time? Or is it an intermittent problem.

    Have you tried researching the service manual for a...
  24. My guess is that just a filter change would not...

    My guess is that just a filter change would not make a significant improvement.
  25. Replies
    4
    Views
    659

    With the key on the pump will only run for a few...

    With the key on the pump will only run for a few seconds and if the ECM does not sense oil pressure, it cuts the pump off.

    Do you have the 1996 Factory Service Manual?
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4