$projecthp

Search:

Type: Posts; User: jseremba; Keyword(s):

Page 1 of 3 1 2 3

Search: Search took 0.01 seconds.

  1. Replies
    6
    Views
    3,281

    No I did not pinch off the return line. I will do...

    No I did not pinch off the return line. I will do that this Friday when I gain access to the car. If I buy an OBD1 scanner. I do not need the engine light to come on, is that correct?
    I thought...
  2. Replies
    6
    Views
    3,281

    That's them. Thank you. Holly crap 90 dollars...

    That's them. Thank you. Holly crap 90 dollars per. Thanks again
  3. Replies
    6
    Views
    3,281

    I was affraid to just go look up injectors that...

    I was affraid to just go look up injectors that fit. The ones that are in the car fit. But, Gordon , Mr. Corvette, said that the resistance is important and these have the wrong resistance. Thank...
  4. Replies
    6
    Views
    3,281

    Fuel injectors

    Hello Everybody,


    I spoke to Gordon Kilebrew and I think he said that my 1985 Corvette uses Lucas fuel injectors 101081. But, every time I try and search Lucas fuel injectors all I get is Lucas...
  5. Replies
    0
    Views
    3,139

    1985 Corvette cables

    I purchased a 1985 Corvette 4 plus 3. The accelerator and other throttle cables were not on the car. I have done a few google searches but have not been able to determine the cables I need. Does...
  6. Replies
    3
    Views
    2,988

    Hello, I checked the resistance of the Fuel...

    Hello,

    I checked the resistance of the Fuel injectors yesterday. All of them have 12.5 Ohms resistance. The stock resistance is supposed to be 14 - 16 ohm. A guy on YouTube said the actual number...
  7. Replies
    3
    Views
    2,988

    Hello 65z01, The SEL does not come on when I...

    Hello 65z01,
    The SEL does not come on when I turn on the key. I forget the page number but I did find the circuit in the FSM. Presently I am on vacation so I don't have the FSM disc or I would...
  8. Thread: ECM for 1985

    by jseremba
    Replies
    0
    Views
    521

    ECM for 1985

    Hello,

    I got my 1985 project car running. But the idle is really bad. I am checking the TPS today. I cannot pull codes. Shorting AB on the ACLC does not work. I am thinking of replacing the ECM....
  9. Replies
    3
    Views
    2,988

    ALCL diagnostic mode

    Hello,

    I am restarting a 1985 Corvette. I have the car running and I am trying to see if the sensors and ECM are working correctly. The previous owner did a little rewiring.
    I put a paper clip...
  10. Replies
    3
    Views
    716

    Help! Two things 1) Someone from the Corvette Forum...

    Two things
    1) Someone from the Corvette Forum had a picture of the connector I need.
    The former owner installed an Alpine security device. There is a LARGE bundle of wires looking at the bundle I...
  11. Replies
    3
    Views
    716

    Help! Yes I am talking about the rear and roof brake...

    Yes I am talking about the rear and roof brake lights.
    When I was driving my other car. I realized that there is no electrical connection to the brake light switch. There is however a connector...
  12. Replies
    3
    Views
    716

    Help! Brake light will not go out

    Hello everybody,


    I own a 1989 6spd Z51 Corvette. I just changed the brake booster and the brake lights are on and will not go out. I tried the adjustment procedure in the manual and the one...
  13. Replies
    4
    Views
    1,782

    Thank you for the advice. Take cars

    Thank you for the advice. Take cars
  14. Replies
    4
    Views
    1,782

    Actually getting a little better at using the...

    Actually getting a little better at using the FSM. And, yes it did help. I went to the CLSTR/CLK fuse and did see as you a lot of stuf is on that fuse. Turns out it was a fuse that I replaced the...
  15. Replies
    4
    Views
    1,782

    interior lights and fuse block

    Hello Everyone,


    I own a 1989 Z51 Manual Corvette. My interior lights and cigarette lighter just stopped working. I am looking at the fuse block diagram and trying to figure which fuse if any...
  16. Thread: new injectors

    by jseremba
    Replies
    0
    Views
    1,095

    new injectors

    So I have a 1989 Z51 6 spd. It was backfiring since I bought it. But it started to backfire so badly on deceleration that it would stall. I read on one of the threads that the injectors could be the...
  17. Thread: Horns

    by jseremba
    Replies
    14
    Views
    2,752

    Dave looks like these guys have got you covered...

    Dave looks like these guys have got you covered good luck
  18. Thread: Horns

    by jseremba
    Replies
    14
    Views
    2,752

    You are correct. Just after I posted the thread I...

    You are correct. Just after I posted the thread I looked at the photos and said . Could use a little cleaning. I had to clean the cigarette lighter with 1500 sand paper so that the lighter worked. No...
  19. Thread: Horns

    by jseremba
    Replies
    14
    Views
    2,752

    Horns

    Hello Everybody

    I own a 1989 Z51 6 spd. My horns do not work. I took the center off the steering wheel and found this. Is this what it is supposed to look like. The spring is on the yellow wire....
  20. Thread: lights

    by jseremba
    Replies
    3
    Views
    1,329

    Okay so this morning armed with the advice you...

    Okay so this morning armed with the advice you people have so graciously provided. I jack up the Corvette. Remove the tail lights and start looking for power and ground. After about an hour and no...
  21. Replies
    2
    Views
    1,275

    Well what I did was connect everything the way...

    Well what I did was connect everything the way the 1987 was set up. And, The CEL went out. But, the cars drive ability has gone to hell. It idles at 600 rpm and goes as low as 400 and STALLS!! YUCK!...
  22. Replies
    2
    Views
    1,275

    vacuum lines and lean code

    hi everybody


    I own a 1989 Z51 6 spd. The car is back firing. The code according to my mechanic is something about running lean. I have the hoses on the top of the canister running correctly. ...
  23. Thread: lights

    by jseremba
    Replies
    3
    Views
    1,329

    lights

    Hello everybody

    So my 1989 6 spd is running but it does not have tail lights. When I press on the brake the brake lights go on, the center console lights go on, sometimes the door chime comes on...
  24. Thread: Brakes

    by jseremba
    Replies
    10
    Views
    1,674

    About 3 hours ago I found and watched those...

    About 3 hours ago I found and watched those videos. I will have to pay attention to where the clips, washer etc. are and see if they match the video.

    Thank you
  25. Thread: Brakes

    by jseremba
    Replies
    10
    Views
    1,674

    What surprised me was the retaining clips and the...

    What surprised me was the retaining clips and the rad are the only thing that holds that caliper in place. Kind of flimsy. I know that the caliper and bracket are not expensive ($90.00 per side). So...
Results 1 to 25 of 53
Page 1 of 3 1 2 3