$projecthp

Search:

Type: Posts; User: Snapper; Keyword(s):

Search: Search took 0.01 seconds.

  1. Replies
    8
    Views
    2,145

    Help! No not yet. Working on repairing other at this...

    No not yet. Working on repairing other at this time. I got a few ideas on several forums.

    Sent from my Moto Z (2) using Tapatalk
  2. Replies
    8
    Views
    2,145

    Help! Thank you very much for the link. My sending...

    Thank you very much for the link. My sending unit is shot and I bought 2 new pumps to install on the current fuel pump assembly. This will help out with a direct replacement.

    Sent from my Moto...
  3. Replies
    8
    Views
    2,145

    Help! Yes I did buy the replacement pumps, in fact I...

    Yes I did buy the replacement pumps, in fact I bought 2 kits because I have two cars. However you do not get what the picture shows, you get two pumps, strainer filters and some hardware. I need a...
  4. Replies
    935
    Views
    351,116

    Notice: I have owned this 91 Corvette 6 speed for over 18...

    I have owned this 91 Corvette 6 speed for over 18 years and purchased it from the original owner. The car is all stock with just 50.000 miles on the clock and runs like the day I bought. The C4 was...
  5. Replies
    8
    Views
    2,145

    Help! ZR-1 Fuel sending unit and fuel pumps needed

    Good day,
    Help needed I have a 1990 ZR1 that does not run and no fuel pressure, I discovered after taking the car apart the fuel pumps are shot and the sending unit is so corroded due to ethenol...
  6. Help! Also GM does not recommend putting fuel injection...

    Also GM does not recommend putting fuel injection cleanernin these cars because the type of fuel injectors in these cars are the disc type injector and the fuel flows over the coil portion of the...
  7. Help! I also have a 1991 6 speed. That had the chatter....

    I also have a 1991 6 speed. That had the chatter. The problem was the dual mass flywheel. This particular fly wheel is a dual flywheel that absorbs all the vibration in the clutch area and makes...
  8. Replies
    3
    Views
    1,850

    Help! The idle position sensor under the throttle body...

    The idle position sensor under the throttle body has dirt in between the cone where it seats with the throttle body base. Remove sensor, clean cone area with throttle body cleaner and it carb...
Results 1 to 8 of 8