$projecthp

Search:

Type: Posts; User: GWinter; Keyword(s):

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. If your going to be working on the care more...

    If your going to be working on the care more often you should order the factory service manual.
  2. Replies
    5
    Views
    343

    how good is your battery bad one can cause all...

    how good is your battery bad one can cause all kinds of strange problems.
  3. Replies
    13
    Views
    629

    did you replace the ignition module in the...

    did you replace the ignition module in the distributor ?
  4. Replies
    10
    Views
    737

    Does it get wet just standing or do you need to...

    Does it get wet just standing or do you need to be moving for it to get wet. My 90 the windshield seal leaks at the bottom and in rain the water blows under the windshield. I have tried injecting...
  5. did you take the slave cyl lose and tilt it to...

    did you take the slave cyl lose and tilt it to bleed? the way they are mounted the bleed screw is usually at the lower end which traps air . would think you cam across this in your searches.
    just...
  6. Replies
    1
    Views
    672

    Sounds like it may be low on Freon. I would hook...

    Sounds like it may be low on Freon. I would hook up a set of gauges and check that first.Something you could try ,locate
    the low pressure switch and jumper the two wires to see if it runs, if it...
  7. Replies
    6
    Views
    2,113

    The engine will most likely overheat without a...

    The engine will most likely overheat without a thermostat , coolant moves to fast to transfer heat.
  8. Replies
    7
    Views
    2,147

    Was the flywheel replaced or just the clutch...

    Was the flywheel replaced or just the clutch disk. OEM was a dual mass flywheel which has lube in it. If it wasn't replaced (they are not available need to replace with standard flywheel/clutch) you...
  9. Replies
    4
    Views
    1,647

    You say the cooling fan was wired to ignition.....

    You say the cooling fan was wired to ignition.. Generally the cooling fans run on relays, relays are wired with coil to 12 v. the relay ground is completed by the ECM to turn on the fans. I would...
  10. Replies
    2
    Views
    1,595

    Help! GM tachs in Camero and Corvette around that time...

    GM tachs in Camero and Corvette around that time period are known to go bad. There are youtubes on how to repair them . If you can't repair it you need to remove the cluster and replace it or have it...
  11. Replies
    3
    Views
    1,794

    I have the OBD I cable on that site, works well I...

    I have the OBD I cable on that site, works well I downloaded some software from the place they listed . The software also works well.
  12. If the car hadn't been moved in a few weeks and...

    If the car hadn't been moved in a few weeks and the tires are a soft compound they could have flat spots which could make it shake badly. Would have to get some heat in the tires to get them to...
  13. Replies
    12
    Views
    2,682

    I don't like what you describe ,my 90 is one of...

    I don't like what you describe ,my 90 is one of the best braking cars I have ever had. I wonder it there is air in the system or the master cyl isn't in the best shape. I use heavy toe pressure to...
  14. Thread: C4 Mufflers

    by GWinter
    Replies
    13
    Views
    3,276

    Do not install a larger pipe from the cat back. I...

    Do not install a larger pipe from the cat back. I installed 3 in OD pipes on my 90 from the cat back and without real loud mufflers I have a terrible drone at highway speed . I attribute it to the...
  15. Replies
    3
    Views
    1,358

    Important! now that DonB mentioned it , yes multiple fuses...

    now that DonB mentioned it , yes multiple fuses contribute. Check every fuse.
  16. Replies
    7
    Views
    1,479

    are you sure your hearing the starter click or...

    are you sure your hearing the starter click or just the relay. The relay may be bad ,
  17. Replies
    9
    Views
    2,208

    Are you suggesting replacing the 90 with a later...

    Are you suggesting replacing the 90 with a later exhaust ?
  18. Replies
    2
    Views
    1,722

    I am not really big on snake oil stuff but before...

    I am not really big on snake oil stuff but before you replace it pick up a bottle of Lucas power steering additive. I had the growling and morning sickness. I put in a bottle of the Lucas and almost...
  19. Replies
    11
    Views
    1,850

    Help! If I remember right the fans run when you jumper...

    If I remember right the fans run when you jumper the OBD port to get codes, you didn't by chance leave a jumper on ? Maybe not applicable to OBDII which started showing up in 95
  20. Replies
    11
    Views
    1,850

    Help! If the air is on both fans should run. Turn the...

    If the air is on both fans should run. Turn the air of if it is on. Wasn't a switch added by previous owner that you turned it on unknowingly ?
  21. No code ? I would check temp sensor and TPS

    No code ? I would check temp sensor and TPS
  22. Thread: Crazy Tach!

    by GWinter
    Replies
    6
    Views
    1,277

    I don't use my radio/stereo enough to even know...

    I don't use my radio/stereo enough to even know for sure if it works. lol But I am going to look for missing screws , cracks and places where I can insulate to get rid of dash noise.
  23. Thread: Crazy Tach!

    by GWinter
    Replies
    6
    Views
    1,277

    Thank you for posting that I need to take my dash...

    Thank you for posting that I need to take my dash apart to replace the heater core so it will be a good time to repair the tach also.
  24. Thread: Crazy Tach!

    by GWinter
    Replies
    6
    Views
    1,277

    I have a 90 and my tac has gotten off farther all...

    I have a 90 and my tac has gotten off farther all the time. I did some research a few yrs ago and the tacs in some yrs corvettes have a bank of resistors in them and one or more of those will fail....
  25. Replies
    9
    Views
    2,208

    You have inspection to contend with so I am not...

    You have inspection to contend with so I am not so sure you can alter the way the exhaust is set up. It is set up with a cat on each side fairly close to the exhaust manifolds. I believe 2 1/2 in...
Results 1 to 25 of 27
Page 1 of 2 1 2