Corvette Action Center - The ultimate online hub of Corvette news and information!
Supporting Vendors / Dealers - Supporting Membership - Advertising Information - Corvette Amazon Shop

Tab Content
No Recent Activity

2 Visitor Messages

  1. I put on the larger yokes for 1350 U-joints.
  2. View Conversation
    I read in one of your posts you have an eaton rear end and are running 650+ HP. I'm thinking about dropping a ramjet 502 in mine but have been stuck on what to do with the rear end. Have you had to modify your differential mounts or any other rear suspension components to hold the torque?
Showing Visitor Messages 1 to 2 of 2
About 1BAD80

Basic Information

About 1BAD80
Auto Build Engineer
Drag racing, Building dragsters & motorcycles
80 Burgandy Rad.Custom & 2003 Anniversary vert.


Total Posts
Total Posts
Posts Per Day
Visitor Messages
Total Messages
Most Recent Message
12-24-08 06:09 PM
General Information
Last Activity
09-20-17 11:06 AM
Join Date
Home Page
No results to show...
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division.  Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for content, comments, or advertising. is independent from GM© and is not affiliated with, sponsored or supported by GM©.  Copyright/trademark/sales mark infringements are not intended, or implied.  All Rights Reserved