Had a little incident where my youngest child decided to hop into the corvette this am and knocked over my magnet tray with all my assembly screws from taking the dash a part. They are now scattered all over the floorboard and garage floor. I was lazy and should have bagged and tagged them, so I'm at fault. But, I want to make sure I use the correct fastener in the correct locations. Anyone know of a diagram with sizes and finishes that I could use as a guide vs. trial and error. I had purchased a full set of interior screws from mid-america already but was not impressed as the finishes were not the same as the original on some of the screws so I want to reuse the existing.