PDA

View Full Version : "28-TCS no comm" What is this???



cwmoss
03-07-04, 12:16 PM
I have cleared all of the codes that were stored . All systems now say "no codes" except for one, which says,"28-TCS no comm" Is this the Traction control System? Where is the module?? I don't have the shop manual for the power train available.
Thanks,
cwmoss (Daryl)

Mr Cowl Hood
03-07-04, 11:09 PM
I'll take a stab at this. Did you just pull it out of storage? If so, go for a ride and see if it goes away. I am not certain what that code means, but it may very well be related to traction control. Post what happens.

Ken
03-07-04, 11:21 PM
"no comm" to me sounds like it would signify "no communication." Now, as for what that would mean... ;shrug

Mr Cowl Hood
03-07-04, 11:47 PM
"no comm" to me sounds like it would signify "no communication." Now, as for what that would mean... ;shrugRight, and perhaps it will begin to communicate once driven? Maybe?;shrug

Anyway, it can't hurt.

maxm
03-08-04, 12:35 PM
Looked at mine today. It says thesame. I have no problems.
Max

cwmoss
03-08-04, 06:59 PM
Found that someone had unpluged the harness from the ebtcm and when they plugged it back together, broke the plastic piece that seperates the wires. WhenI unplugged it, there were pieces of plastic in there, I guess keeping it from getting a good connection. My lights in the dash are off. The only code I have now is saying I have an internal malfunction in the ebtcm. I guess that is why it was unplugged before. Thanks for the replies.