Supporting Vendors / Dealers - Advertising - Shop

Technical Article: Leak Less - Swapping the Centerhead in Your Corvette and Keeping Leaks at Bay

By John Hinckley, Corvette Enthusiast Magazine
Used here with permission.
Copyright John Hinckley, Corvette Enthusiast Magazine


The objective of this article is to walk you through an intake manifold swap and identify the tools, materials, and tips involved. You can do this in an afternoon, and no special tools are required. This particular swap was done to replace an incorrectly dated intake with an identical part with a correct date, but the basic principles are the same if you’re upgrading to an optional-engine intake.

This 4-page PDF article is linked below:

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files (1)
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
Head Casting Numbers: Chevrolet Small Block Engines
Viewed 5695 times since Tue, Jul 15, 2014
Service Bulletin: Minor Paint Repair Without Repainting
Viewed 736 times since Tue, Jul 15, 2014
Technical Article: Problems I have Seen with Commercially Rebuilt Q-Jets
Viewed 814 times since Fri, Jul 4, 2014
Chevrolet Service Bulletin: Information on Tire Radial Force Variation (RFV)
Viewed 3443 times since Mon, Jul 14, 2014
Service Bulletin: Delco Freedom Battery Diagnosis Information
Viewed 3738 times since Tue, Jul 15, 2014
Technical Article: Horsepower vs. Torque
Viewed 765 times since Tue, Jul 15, 2014
Technical Article: How to Repair & Rebuild your Alternator
Viewed 1147 times since Fri, Jul 4, 2014
Technical Article: Synthetic Oil Use
Viewed 1406 times since Tue, Jul 15, 2014
Technical Article: How to Install a BG Speed Demon (Basic)
Viewed 671 times since Fri, Jul 4, 2014
Technical Article: Spring Thing - Putting the "Spring" Back In Your Corvette’s Step
Viewed 657 times since Tue, Jul 15, 2014