Supporting Vendors / Dealers - Advertising - Shop

1985 Corvette: Service News: Revised Differential Case Cross Pin Installation Procedure

Subject: Revised Differential Case Cross Pin Installation Procedure
Model and Year:  1985 Corvette
Source:  Chevrolet Service News
Page Number:  NA
Date:  March/April 1985 - Volume 57 - Number 2

Figure 4B-39 shown on Page 4B-16 and step 10 shown on Page 4b-17 of the 1985 Corvette Shop Manual (ST-364-85) have been revised as indicated below.  Fig. 4 replaces Figure 4B-39 presently shown in the Shop Manual.

10.  Position the cross pin shaft in the case and drive in with a hammer.  Be sure the retaining pin hole of the cross pin shaft is properly aligned to allow installation of the retaining pin.  Install the retaining pin to the proper depth using a punch and stake in place at both ends of the case.

1985 Corvette Revised Differential Case Cross Pin Installation Procedure

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code