Supporting Vendors / Dealers - Supporting Membership - Advertising Information

Corvette Action Center Knowledgebase

Print Friendly and PDF
Knowledgebase Home | Glossary | Favorites | Contact | Login Knowledgebase Home | Glossary | Favorites | Contact | Login
Search the Knowledgebase Browse by Category
1984 - 1989: Service Bulletin: Steering Gear Intermediate Shaft Torque Specifications
Article Details

Last Updated
9th of February, 2012


Bulletin Number:   89-258-3B

Section:  3B

Date:  September 1989

Subject:   Steering Gear Intermediate Shaft Torque Specifications 

Models:
   1984-89 Y Car 

To:  All Chevrolet Dealers


The following specifications supersede information previous published in the 1984 - 1989 Corvette Service Manuals, Section 3B5 (1984-88) and Section 3F3 (1989).
 

Model Year Intermediate Shaft to Column Intermediate Shaft to Gear
1984 48 Nm (35 lbs. ft.) 48 Nm (35 lbs. ft.)
1985 48 Nm (35 lbs. ft.) 48 Nm (35 lbs. ft.)
1986 34 Nm (25 lbs. ft.) 48 Nm (35 lbs. ft.)
1987 34 Nm (25 lbs. ft.) 48 Nm (35 lbs. ft.)
1988 34 Nm (25 lbs. ft.) 48 Nm (35 lbs. ft.)
1989 34 Nm (25 lbs. ft.) 48 Nm (35 lbs. ft.)

Please make note of these changes in each of your manuals. 

COPYRIGHT 1989
CHEVROLET MOTOR DIVISION
GENERAL MOTORS CORPORATION
ALL RIGHTS RESERVED

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.

© Copyright General Motors Corporation. All Rights Reserved

Visitor Comments
No visitor comments posted. Post a comment
Post Comment for "1984 - 1989: Service Bulletin: Steering Gear Intermediate Shaft Torque Specifications"
NOTE:  Please do not ask technical questions here as you will not get a response. To ask questions, please join our forums and post your question there.

To post a comment for this article, simply complete the form below. Fields marked with an asterisk are required.
   Your Name:
   Email Address:
* Your Comment:
* Enter the code below:
 
Related Articles
No related articles were found.
Attachments
No attachments were found.

Continue

© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division.  Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©.  Copyright/trademark/sales mark infringements are not intended, or implied.  All Rights Reserved