Corvette Action Center - The ultimate online hub of Corvette news and information! Click here to go to the Corvette Forums!


Supporting Vendors / Dealers - Supporting Membership - Advertising Information - Corvette Amazon Shop

Search:

Type: Posts; User: The Plastic Lizard; Keyword(s):

Search: Search took 0.01 seconds.

  1. Replies
    2
    Views
    888

    Any other suggestions?

    Any other suggestions?
  2. Replies
    2
    Views
    888

    After tb overhaul, high idle?

    I bored the tb to 2". Did all the other crossfire hacks for more air and fuel pressure.

    now when I try to balance tb, I cannot get idle lower than 975 in gear.

    the rear tb is sitting on the...
  3. Heavy Duty Polymer Rear Hatch Vent

    Do you still have this for sale? If so I'll take it. Send me a pm or let us know its sold.
  4. Replies
    11
    Views
    2,874

    Sorry, meant to say I bought them for 35. Will...

    Sorry, meant to say I bought them for 35. Will sell for 20
  5. Replies
    11
    Views
    2,874

    FS: pilot drill and mill to do bushing work.

    I have the drill and pilot mentioned on the cube studio instructions.
    i'll take $35 for them.

    Only used once. Ok! Actually 4 times.

    Normally I would post in the for sale section, but since...
  6. Replies
    3
    Views
    1,539

    What is correct idle in gear?

    So I am tuning up the 84 crossfire tomorrow. Have seen conflicting information on the correct idle speed. What is it supposed to be in drive with foot on brake and in park?
    Thanks
Results 1 to 6 of 6
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division.  Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©.  Copyright/trademark/sales mark infringements are not intended, or implied.  All Rights Reserved