Idaho Slim
Member

12 Likes

1. 
   Idaho Slim liked post by John Robinson On thread : Sad Member News To Report

   I'm the son of this forum member and am sad to report that John C. Robinson passed away at 11:35 last night after a two week stay in the hospital. My Dad had battled health problems for many years...

   Liked On: 05-21-13, 06:25 AM

2. 
   Idaho Slim liked post by Hib Halverson On thread : C4 D44 drop in Unit ?

   1) Torque beam, prop shaft, drive axle 2) Not sure, but I know Zip Products sells the drive axle assemblies which are reman. 3) Probably not gonna happen. The very rare 3.54 gearsets for D44s are,...

   Liked On: 05-08-13, 11:49 AM

3. 
   Idaho Slim liked post by G Winter On thread : found mice under my dash anyone...

   I take paper plates. put an open bar of Irish Spring soap on each. place one on each tire , one on top of engine , one on the floor of the front seat and one in the back hatch area. I have been doing...

   Liked On: 05-08-13, 06:46 AM

4. 
   Idaho Slim liked post by ras On thread : found mice under my dash anyone...

   I have been fighting these for a long time and have tried moth balls on outside of car. This works but you have to put them everywhere they can access the car and remember they like to jump.Problem...

   Liked On: 05-05-13, 07:25 PM

5. 
   Idaho Slim liked post by Hib Halverson On thread : found mice under my dash anyone...

   Two reason mice get in: 1) Good place to nest. 2) They like to sharpen their teeth chewing on wiring and plastic parts. Get a cat.

   Liked On: 05-04-13, 11:47 AM

6. 
   Idaho Slim liked post by pmanobianco On thread : new tires

   This car was bought by the original owner as a car for collection not a driver. I'm the 3rd owner with a 50page binder of every record on this car. Now with the original tires off the car I can enjoy...

   Liked On: 04-25-13, 06:44 AM

7. 
   Idaho Slim liked post by Toms01 On thread : Baby got new shoes! With 11x17's :)

   Those really don't stick out that far, do they? Looks good. I know you've been on the search for some time.

   Liked On: 04-13-13, 08:39 PM

8. 
   Idaho Slim liked post by redc4corvette On thread : Going to the Dragstrip, .... Any suggestions?

   If you realy want to race your car and want the info here is my experience. These are my troubles. You have a 4l60e trans ,that will shift it's self. Don't shift it put it in drive TO LAUNCH not...

   Liked On: 07-08-12, 11:27 AM

9. 
   Idaho Slim liked post by Mac On thread : The 10 Greatest Muscle Cars of All Time

   In the long run, the Cobra is cheaper... :chuckle -Mac

   Liked On: 06-06-12, 09:54 PM

10. 
    Idaho Slim liked post by Remo On thread : The 10 Greatest Muscle Cars of All Time

    Unlike many of the muscle cars on this thread....this one will not only leave you at the stop light...it will also run away from you in the corners.;) ...

    Liked On: 06-06-12, 09:50 PM

11. 
    Idaho Slim liked post by GTR1999 On thread : Rear Axles and Horsepower ?

    The stock vette diffs have weak areas, some years worse then others. With that said, yes they can be built to handle power levels up to 1000 hp(full 1480 12 bolt conversion). The best years to...

    Liked On: 05-24-12, 06:43 AM

12. 
    Idaho Slim liked post by kiharaz28 On thread : Build sheet on my 96 col. Ed lt4

    HELLO EVERYONE I JUST FOUND AND REMOVED THE BUILD SHEET ON MY 96 CE. ITS WAS ON TOP OF THE GAS TANK BETWEEN THE TANK AND THE STRAP ON THE PASSENGER SIDE IT WAS A RELATIVELY EASY JOB IF U HAVE THE...

    Liked On: 05-12-11, 06:27 AM