I am looking for a toneau that does not require drilling to install. I have seen some that have clamps, but now I am not sure where I saw them. Any help???
Mods to date:
383 Stroker, Heads/cam/ intake, Ported Plenum, Ported and siamesed runners, Big Mouth Manifold with EGR delete, 52MM TB,TPIS Long Tube Headers, 3" exhaust, Dynomax UltraFlow Mufflers, Holley AFPR, MSD 6AL, 30# injectors,255 LPHWalbro fuel pump, Vortex Ram Air, MAT Relocation kit, TB Bypass,Heated 02,2400 RPM stall torque converter, Pioneer Head unit, Infinity speakers.
Mods soon to come:
Super Ram/Mini Ram?? 3.73 rear gears.
1973 Bucaneer Red Pontiac Trans Am 455 w/4sp
1971 Starlite Black Pontiac Formula 455 auto w/air.
2004 Victory Red Chevy Silverado Z71 5.3
I take it you want a cover for a P/U truck. If so, I have an Extang Tonnau on my truck. No drilling required. It attaches with ther 3M grey tape. Iv'e had it on there for over a year with no problems at all.
Here's what I have http://www.extang.com/docs/tufftonno.html
They make the same thing, but it also tilts.
I have an ARE......great top, runs about 1200. but is solid and no drilling required...
By MagicDragon in forum Callaway Corvette Forum
Last Post: 09-08-04, 06:40 PM
By Aaron D in forum LT4 Forum
Last Post: 07-27-04, 07:47 PM
By tigernut in forum C1 & C2 General and Technical Discussion
Last Post: 04-10-04, 10:46 AM
By 3 Deuce in forum C4 Technical and Performance
Last Post: 04-22-03, 08:07 PM
By 72Slydog in forum C3 Technical and Performance
Last Post: 06-10-02, 09:26 PM
Owned and Operated by © 2000-2015 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved