-
Advice Please On GEARS
I have an 05 Z51 Corvette with the 6 speed standard. I am scheduled to run my car next weekend at Sebring Raceway. Its a 3.7 mile road course. I also scheduled for GM to install this Teusday a set of 4:10 rear gears. As I was laying in bed thinking about how different the car is going to feel and how different it should be at Sebring raceway I thought hmm I wonder if there is a break-in period for the rear gears. In essence IM going to install them drive 50 miles to track then beat the snot out of the car.
Im wounder in anyone out there knows if there is a break in period for the gears and whould you wait to go to the track or go and not worry about it
Im open to advice please
Similar Threads
-
By fredk in forum C4 Technical and Performance
Replies: 13
Last Post: 07-15-10, 06:28 AM
-
By a97cobra in forum C4 Technical and Performance
Replies: 7
Last Post: 07-15-05, 10:46 AM
-
By fredk in forum C4 Technical and Performance
Replies: 9
Last Post: 03-11-05, 04:49 PM
-
By regalniz in forum C4 Technical and Performance
Replies: 7
Last Post: 06-25-03, 11:11 PM
-
By M.A. CRISSIS in forum C4 Technical and Performance
Replies: 5
Last Post: 07-02-02, 01:32 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Owned and Operated by © 2000-2013 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved
Bookmarks