Corvette Action Center - The ultimate online hub of Corvette news and information! Click here to go to the Corvette Forums!


Supporting Vendors / Dealers - Supporting Membership - Advertising Information - Corvette Amazon Shop
Results 1 to 6 of 6

Thread: worn bolster

  1. #1
    Registered User
    Join Date
    Sep 2009
    Location
    NJ
    Posts
    69
    Corvette(s)
    1993 red 08 yellow z51

    Default worn bolster

    hello everyone, i have 9500mi. on my 08 and the drivers side seat bolster is getting worn is this covered by warranty? thanks kraz

  2. #2
    Member
    Join Date
    Sep 2006
    Location
    Carlsbad,Ca.
    Posts
    872
    Corvette(s)
    2006 C6Z DSOM

    Default

    Only if there's a defect in materials or workmanship. What's your "technique" for getting in/out of you car? Are you sliding your butt across the seat causing wear?

  3. #3
    Registered User
    Join Date
    Sep 2009
    Location
    NJ
    Posts
    69
    Corvette(s)
    1993 red 08 yellow z51

    Default

    hi at first i did but now i use the easy exit button kraz

  4. #4
    Member motorman's Avatar
    Join Date
    Mar 2002
    Location
    pa
    Posts
    883
    Corvette(s)
    2008 Crystal Red Tint Coat

    Default

    i had a problem with my red one showing black and it was not something on the bolsters as it would not clean off so it was replaced
    retired race engine builder,former NASCAR tech inspector,corvette owner since 1959, new corvettes owned,59,62,63,64,65,66,97,99,02,05, 2008 is in my garage, 2008 sold and waiting for my C-7

  5. #5
    Registered User
    Join Date
    Sep 2009
    Location
    NJ
    Posts
    69
    Corvette(s)
    1993 red 08 yellow z51

    Default

    hi what dealer did you take your vette to?

  6. #6
    Member motorman's Avatar
    Join Date
    Mar 2002
    Location
    pa
    Posts
    883
    Corvette(s)
    2008 Crystal Red Tint Coat

    Default

    Quote Originally Posted by kraz View Post
    hi what dealer did you take your vette to?
    Grabiak in new alexadria pa where i have bought all 11 of my new corvettes
    retired race engine builder,former NASCAR tech inspector,corvette owner since 1959, new corvettes owned,59,62,63,64,65,66,97,99,02,05, 2008 is in my garage, 2008 sold and waiting for my C-7

Similar Threads

  1. can a worn cam lobe do this?
    By Oldskool153 in forum C4 Technical and Performance
    Replies: 17
    Last Post: 05-16-10, 01:19 AM
  2. Question: 1990 Seat Memory, and Seat Bolster Buttons
    By JamesBaines in forum C4 General Discussion
    Replies: 4
    Last Post: 07-04-09, 09:58 AM
  3. Worn A4 Shifter??
    By gw962 in forum C5 Technical and Performance
    Replies: 2
    Last Post: 02-02-09, 08:26 PM
  4. GM Press Release: GM to Bolster Liquidity by $15 Billion through 2009
    By Rob in forum News and Announcements Forum
    Replies: 3
    Last Post: 07-17-08, 12:57 AM
  5. 1990 Sport Seat Bolster
    By Greg Albers in forum C4 General Discussion
    Replies: 4
    Last Post: 08-24-06, 04:19 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division.  Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©.  Copyright/trademark/sales mark infringements are not intended, or implied.  All Rights Reserved