On a 2008 C6:
1) how many O2 sensors are there &
2) can someone tell me where they are?
I need to make sure they are all nice and snug.
Technical Writer for Internet & Print Media
There are four sensors.
One upstream of each cat converter. And one just downstream of each cat.
It's unlikely you need to tighten them, but you insist, you'll need an oxygen sensor socket and, if you remove them, you need a little bit of that special glass impregnated antiseize lubricant that is used on O2S threads.
oh that sounds fun....
Originally Posted by Hib Halverson
By Achilles in forum C4 Technical and Performance
Last Post: 04-11-10, 12:07 PM
By TUPELOLT4 in forum C4 Technical and Performance
Last Post: 09-27-09, 11:23 AM
By C4Tom in forum C4 Technical and Performance
Last Post: 04-05-06, 10:27 AM
By JGatlin in forum C4 General Discussion
Last Post: 04-10-04, 06:46 PM
By grumpyvette in forum General Automotive Discussion
Last Post: 03-22-04, 09:09 AM
Owned and Operated by © 2000-2015 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved