I have bought a set of four used tire sensors from a 2007 Corvette. They are marked with LV, LA, RV,RA. L=Left R=Right But i don not understand, does it matter in which wheel i place them in? And was do V and A stand for?
Those have no bearing on position.
They are individually programmed and it doesnt matter where you put them.
Those are manfacturer specific letters, not GM identification.
By Rob in forum C6 Technical and Performance
Last Post: 01-24-07, 09:38 AM
By Hib Halverson in forum C4 Technical and Performance
Last Post: 07-14-05, 01:44 PM
By jenavet in forum General Automotive Discussion
Last Post: 11-30-04, 12:26 PM
By Hib Halverson in forum C4 Corvette ZR-1
Last Post: 10-21-03, 07:00 AM
By Hib Halverson in forum C5 Technical and Performance
Last Post: 09-29-02, 10:08 AM
Owned and Operated by © 2000-2015 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved