Backglass falling out.
I'm working on a 2001 convertible. The backglass is falling out and I'm not sure what to use to reinstall it. Does anybody have any suggestions. Its not like
the old sewn in tops, this is some type of clear type tape or special epoxy. Has anybody ran into this before and what do you use to reinstall it.
By ELKYNUT in forum C4 Technical and Performance
Last Post: 08-29-04, 02:35 PM
By Blade in forum C5 General Discussion
Last Post: 06-23-04, 11:31 AM
By 65coupe in forum C6 General Discussion
Last Post: 02-20-04, 11:25 PM
By vuk in forum C4 Technical and Performance
Last Post: 12-12-03, 07:29 AM
Owned and Operated by © 2000-2013 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved