Corvette Action Center - The ultimate online hub of Corvette news and information! Click here to go to to the 2014 C7 Corvette Center

Supporting Vendors / Dealers - Supporting Membership - Advertising Information
Results 1 to 3 of 3

Thread: High Carbon Steel Pulley

  1. #1
    Supporting Member Vettefan87's Avatar
    Join Date
    Jan 2004
    Location
    Northern Indiana
    Posts
    3,287
    Corvette(s)
    1987 Z52 Black Convertible

    Default High Carbon Steel Pulley

    Well the quest for mods never ends does it?? Since this is relatively cheap I figured I would post. I have not looked outside of Mid America so if anyone has anything better, or what not let me know. http://www.madvet.com/shop?frame=3.846
    Now is it really worth it? By the time you buy that and the new belt and what not it is over 100 bucks. What are the pro's and cons on this, and how hard a install is it? I don't really consider my vette a daily driver to go to school, and work. Thanks guys.

  2. #2
    Supporting Member Vettefan87's Avatar
    Join Date
    Jan 2004
    Location
    Northern Indiana
    Posts
    3,287
    Corvette(s)
    1987 Z52 Black Convertible

    Default

    Anybody done this???

  3. #3
    Supporting Member Vettelt193's Avatar
    Join Date
    Jun 2002
    Location
    Tallahassee, FL
    Posts
    2,752
    Corvette(s)
    none right now :(

    Default

    Yes, that works. do a search on underdrive pulley and you should find more about them

    They work better on the L98 than LT1/4, because the waterpump is on the pulley system on the L98... a good mod for a few more HP, and quicker response from the engine.

Similar Threads

  1. Oil temp before nailing it?
    By froggy47 in forum General Automotive Discussion
    Replies: 54
    Last Post: 09-17-07, 10:32 PM
  2. High Performance Composites
    By Ken in forum General Automotive Discussion
    Replies: 0
    Last Post: 04-20-04, 08:31 PM
  3. aftermarket pan and high voluum oil pump are worth the cost
    By grumpyvette in forum General Automotive Discussion
    Replies: 1
    Last Post: 01-30-03, 05:13 PM
  4. [Press]: Carbon Fiber For C6?? - Interview with Dave Hill
    By Rob in forum C6 Technical and Performance
    Replies: 6
    Last Post: 11-13-02, 10:05 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division.  Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©.  Copyright/trademark/sales mark infringements are not intended, or implied.  All Rights Reserved