dose anyone know an EASYER way to replace the bottom radiator hose other than busting ur knuckles in that tight space in dead front of motor.??? I was thinking of draining the fluid and cutting it in half and pulling it out like that. any suggestions?
Cutting it is just fine...just be careful, the tanks and outlet where the hose connects is plastic.
Owned and Operated by © 2000-2013 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved