Replacing the ABS Unit- Any Advice?
I am replacing the ABS Pump Unit on my 89 Vette. The modulator valve went out, so the whole unit has to be replaced. Has anyone done this and knows of any thing to watch out for? The project seems fairly straight forward- unplug the connetctors and remove the brake lines, then reverse order and bleed the system......
My manual does not cover this unit.
By Zixxer in forum C4 Technical and Performance
Last Post: 05-24-04, 08:31 PM
By ShaneL in forum C4 Technical and Performance
Last Post: 05-14-04, 10:25 PM
By olefam in forum C4 General Discussion
Last Post: 04-19-04, 06:27 PM
By Alfonso Gomez in forum C4 Technical and Performance
Last Post: 03-09-03, 06:14 PM
By Rob in forum Wrench & Socket
Last Post: 05-19-02, 11:16 AM
Owned and Operated by © 2000-2013 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved