Front Plate Install
I hope you guys and girls donít mind all the questions, but I am new to Corvette ownership.
I live in Illinois and they require a front plate. How dose the front bumper thingeee come off so a plate can be installed, or do you just screw it on to that thingeee?
There are two screws located in the base. You have to get down to that level to see 'em. Then install your plate. You can buy a clear cover that goes over the plate and 'fill' the bumper back out to it's shape.
Welcome to the CAC
Chris aka "Top"
1SG, US Army (Retired)
1986 Indy Pace Car Dark Red Convert, TBI bypass, K&N, open airbox, manual fan switch, muffler elminators, Hypertech chip, manual aux fan, 4+3 button by Len
Thanks Top, I would have never seen those unless I was just hanging around down there!
I got pulled over last week for no plate, so I put it on. I don't like the way it looks, so I'm interested in the clear thingee that you talked about. Is it shaped like the original insert? Where do you buy one? Thanks
Mid America Designs has them fairly reasonable. The link is the following:
Owned and Operated by © 2000-2013 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved