Corvette Action Center - The ultimate online hub of Corvette news and information! Click here to go to to the 2014 C7 Corvette Center

Supporting Vendors / Dealers - Supporting Membership - Advertising Information
Results 1 to 2 of 2

Thread: Convertible Frame Supports

  1. #1
    aqua94
    Guest

    Default Convertible Frame Supports

    I have noticed a difference in the way my 1994 coupe handles and drives without the removeable top on. I have been told the convertible model has extra frame supports/braces underneath the car. I was just wondering several things. One, can these extra supports be installed on a coupe? Two, has anybody done this modification? Three, were the mods worth the effort? I hope somebody can help me out here. Thanks very much in advance!

  2. #2
    Supporting Member Tuna's Avatar
    Join Date
    Mar 2003
    Location
    Mustang, OK
    Posts
    3,537
    Corvette(s)
    '13 427 60th (+V Wagon & Volt)

    Default

    Yes the X-brace can be installed on coupes - it adds an extra 150 pounds to the car and lowers the ground clearance an inch or more.

    It would cut down on the flex, especially with the targa roof off.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division.  Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©.  Copyright/trademark/sales mark infringements are not intended, or implied.  All Rights Reserved