Min thickness for refacing/turning rotors
I am going to change my brakepads and is thinking of refacing my rotors while i am at it.
Does anybody know whats the minimum thickness of the brake rotors is, front and rear??
If they are stock rotors, it should be stamped or cast into the rotor somewhere what min thickness is. Most auto supplies that turn rotors will also look it up before they turn them for you.
I did not know that but thats great.
Owned and Operated by © 2000-2013 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved