Pass side seat controls dead after I work on dr side. Help?
I took out my dr side seat to do major carpet cleaning. Just 4 bolts & 3 elec conn. Dual sport seats. Put it all back & now the pass side does not respond. The lumbar (pass side & dr side) is fine. It's just the elec back/fwd tilt etc that does not work on the pass side.
I took apart & reconn the three elec plugs & I did not touch the center console selector at all?
Gone but not forgotten
Yeah, it's just a loose connection. It can be frustrating, but you're just going to have to hunt it down by jiggling the wires and connectors until you find it.
Thanks Ken, one other suggestion was that I switched the connections (there's a Y). As I did not mark them b4 I took them apart, there's a 50/50 chance that this might be the case.
The pull apart connectors were switched. I didn't mark them when I took them apart. When I reconnected them I put like colors with like colors (wrong). All works fine now! Thanks guys!
Owned and Operated by © 2000-2013 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved