Corvette Action Center - The ultimate online hub of Corvette news and information! Click here to go to to the 2014 C7 Corvette Center

Supporting Vendors / Dealers - Supporting Membership - Advertising Information
Results 1 to 5 of 5

Thread: Help ! Starter problems

  1. #1
    Member Radar's Avatar
    Join Date
    Oct 2001
    Location
    Oconomowoc, WI
    Posts
    252
    Corvette(s)
    1989 Medium Blue Metalic Convertible

    Default Help ! Starter problems

    Out of the blue, the starter on my 89 vert makes this awful noise !!



    It sounds like the noise a starter makes if you try to start an engine that is already running. But......my engine is off! There is a terrible and LOUD clashing noise. If I stop and try again, presto.....starts fine with a normal starter sound. May only happen once in a hundred starts.

    Doesn't the starter solenoid have to pull the bendix into the flywheel ring gear before the end switch energizes the starter motor? So why does the noise sound like the starter motor is energized and turning before the bendix engages. Any ideas on what causes the noise?

    I will replace the starter but I want to understand whats wrong so I don't change it for nothing and find it is something else.

    Your advise is appreciated!
    Radar
    1989 Medium Blue Metalic Convertible, Hypertech stg 2, 160 deg t'stat, 48,800 mi.
    Save the Wave! "In God We Trust"

  2. #2
    Member spyysee's Avatar
    Join Date
    Jun 2002
    Location
    NY LI Metro
    Posts
    125
    Corvette(s)
    1987 black beauty, all ez mods, owned '62,'78

    Default

    replace the starter. It wil only get worse.
    the solonoid is sticking and when it does energize the motor is already spnning.

    p.s. It's a b@#ch. I read on a similar post about an after-market hi torque that is smaller and therefore easier to install.
    Whish I knew that before I did mine.
    Good Luck

    http://corvetteactioncenter.com/foru...threadid=12912

  3. #3
    Member vms4evr's Avatar
    Join Date
    Jul 2001
    Location
    Raleigh, NC
    Posts
    702
    Corvette(s)
    1992 LT1 Slut Lipstick Red Coupe

    Default

    You got it to start and it stopped grinding. You're lucky. When my started solenoid kicked the bendix gear in it never let go. Car made a god awful racket. But to make matters worse when I turned the key to off the darn thing wouldn't stop cranking. I was lucky enough to be in my garage at the time. Should have seen how fast I made it to the tool box and back to the car with a wrench and got that negative cable off the battery....

    Starter hosed. But I got a new GM, not rebuilt for about $225. So I went with the GM. The old one's bendix was worn down pretty good but because it is softer metal than the flywheel there was no harm done. Install new starter and good to go again.

    I wouldn't wait too long if I were you. And stay away from Pep Boys, Autozone, etc.. You may get it cheaper but you'll have the privilege of replacing it more often. Mine was the original, so it lasted 9yrs... Not bad.

  4. #4
    Member BigRed's Avatar
    Join Date
    May 2001
    Location
    Edmonton
    Posts
    1,233
    Corvette(s)
    1985 Bright Red Rocket

    Default

    HA I KNEW I wasnt alone out there! Mines doing the EXACT same thing...Its the starter replace it your smokin!

  5. #5
    Member Radar's Avatar
    Join Date
    Oct 2001
    Location
    Oconomowoc, WI
    Posts
    252
    Corvette(s)
    1989 Medium Blue Metalic Convertible

    Default

    Thanks for all of the feedback. I will pull that starter and replace it very soon. I like the suggestion to get a new GM part.

    Thanks,
    Radar.
    1989 Medium Blue Metalic Convertible, Hypertech stg 2, 160 deg t'stat, 48,800 mi.
    Save the Wave! "In God We Trust"

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division.  Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©.  Copyright/trademark/sales mark infringements are not intended, or implied.  All Rights Reserved