Starts eratic, runs rough, stalls
Got into my 87 Convertible, ( 42,000 miles) started it up like I have done a hundred times with no problem, tonight I backed out of my garage the car stalled, would not start for a few minutes, car turns over but nothing. When car does start, it stalls a few seconds after I stop giving it gas. Please Help!!!
Gone but not forgotten
It sounds like the fuel runs out- I pulled a code 34, can it be the MAF sensor...?
The Mass Air Flow (MAF) sensor measures the amount of air which passes through it. The ECM uses this information to determine the operating condition of the engine, to control fuel delivery.
The oil pressure switch or the ECM, through control of the fuel pump relay, will provide 12 volts for the MAF power relay which provides the 12 volts needed by the MAF sensor.
The ECM provides a current limiting 5V on the signal line (CKT 998). The MAF sensor then changes the signal by dropping the voltage so that with low air flow the ECM sees a low voltage and a high air flow will cause the ECM to see the near the 5 volt supply.
Code 34 indicates the ECM has seen low air flow less than 2.5 gm/sec (low voltage) for one second when:
- Engine is first started
- RPM above 600
- TPS above 6%. To obtain 6%, the engine has to be running at about 2300 rpm in neutral.
- A Code 34 may be caused by an engine that exhibits a low, rough, unstable or incorrect idle problem. If this condition exists, disconnect the MAF sensor. If the unstable idle still exists, see symptoms in Section "B" of the Service Manual. If the idle improved with the sensor disconnected, replace it. Code 34 could also result from a dirty or misadjusted throttle body. Refer to Section "C2" of the Service Manual for minimum idle speed adjustment.
- This test will determine if the conditions still exist to set a code or if the problem is intermittent:
With the MAF sensor disconnected, the ECM should see a high voltage and set a Code 33. If a Code 34 resets, then the wiring or the ECM is at fault.
Clear as mud now?
I hope this helps you; as you may already be aware, I'm having my own fun with Code 33 on my new hot rod engine.
he only has 42K miles on it
i think its a vacume line, they can come off easy some times
usually when u get code 33 it means your not in time
i had it and thats hoi cleared it
does your car sound like its missing cyclinders
we need more infro
if your alt is bad or your battery
it will do what u described
see what your volts are reading on that
i doughts its a sensor,, i think most sensors last till 100K miles
but i think peopl ehave replaced them aroudn 50K miles but ususally on like 93's and up
Thanks guys, I have a new battery, new alternator, new fuel filter, checked all the vacuum lines, and fuel pressure, everything ok. I picked up a new MAF relay this morning, ( only $11.00) I'll try that, getting desperate, car still starts, idles, rev it up, it stalls and will not start for a while.
o i know what, a bad coil
a bad coil will work when its cold
and then when the coil warms up it stops working
maybe a cloged cat
Owned and Operated by © 2000-2013 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved