Regarding the C4 serpentine belt tensioner...
How far do you have to turn it to get sufficient tension off the belt to remove the belt? Thanks for any fedback.
I was working with the 15mm hex nut on the pulley, instead of the square hole in the tensioner frame.... Sheesh!!
- Online Member
Ha...don't feel bad I did the same thing once........
By Crankpin in forum C4 Technical and Performance
Last Post: 08-06-12, 06:37 PM
By Curious George in forum C5 General Discussion
Last Post: 07-23-10, 11:40 AM
By *89x2* in forum Callaway Corvette Forum
Last Post: 07-08-06, 09:57 PM
By fretwire3d in forum C4 Technical and Performance
Last Post: 06-05-03, 01:14 AM
By ddfisher1 in forum C5 Technical and Performance
Last Post: 08-24-02, 03:11 AM
Owned and Operated by © 2000-2013 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved