96 Sun Visor Installation
Can someone share the secret to reinstalling the Sun Visor spring and retainer? How can I compress the spring and get the retainer down far enoung to start the nut?
Thanks for your help
Sun visor reinstall
I did that project a year ago. If my memory serves me, I used a small socket and extension like a nut-driver to press the nut down on the spring and onto the threaded stud. it wasn't terribly difficult.
As a side note, I used the padded vinyl black sunvisors off of a wrecked Chrysler sebring to replace the ratty originals. they look great and cost about $12 for a pair at a pick-it-yourself wrecking yard. I swapped the hardware (that I had taken off months earlier) and reinstalled them in a few minutes.
Now I'm trying to figure out how to use the electric supply for the mirror for a radar detector!
By johns81 in forum L81 Vette Registry Forum
Last Post: 09-05-12, 08:04 PM
By joelgjoel in forum C5 General Discussion
Last Post: 11-19-08, 07:58 AM
By markiemyster in forum C1 & C2 General and Technical Discussion
Last Post: 04-09-06, 08:19 PM
By dburgjohn in forum C4 Technical and Performance
Last Post: 10-26-03, 10:00 PM
By RayL81 in forum C3 Technical and Performance
Last Post: 08-30-02, 05:41 PM
Owned and Operated by © 2000-2013 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved