Brake Light Switch
I need to have some advice about how to adjust the Stop Lamp, TCC, and cruise control switch.
Here is what I have been doing.
1. Push the switch all the way against the brake pedal.
2. Depress the brake and bottom out the switch.
3. Release the brake and pull it back away from the floor until the switch stopped clicking.
As soon as I drive the car the switch moves and the adjustment I have is lost.
What am I not doing right that the switch will not stay in position in the bracket?
Can I do anything to cure this problem or is the barrel of the switch worn to the point that it cannot stay put.?
One last question has anyone put 5 minute epoxy on one of these and adjusted it and waited for the glue to cure and have it work?
Your plastic retainers are probably dry and cracked.
Not uncommon, and they can be purchased locally at parts stores.
By Ripp 73 in forum C3 General Discussion
Last Post: 12-26-04, 08:20 AM
By BlueMan in forum C5 General Discussion
Last Post: 07-02-04, 07:34 PM
By BlueMan in forum C5 Technical and Performance
Last Post: 07-02-04, 12:49 PM
By 1981 in forum C3 Technical and Performance
Last Post: 07-15-03, 12:18 AM
By jbonifas in forum C3 Technical and Performance
Last Post: 03-03-01, 10:16 AM
Owned and Operated by © 2000-2013 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved