rear suspension diagram
Where can I find a diagram for the rear suspension for a 1996 vette? I went to install a new hub ass'y. and there appeared to be part of a seal dangling in the opening where the spline enters the housing. I have a copy from the chevy dealer and there seems to be a seal/washer (item 48) that locates on the spline prior to entering the housing and the hub ass'y. I tried to locate a diagram on the web, but I didn't have any luck. I'm new to computers/internet and may not have enterd the right info. So any help that you could supply wopuld be greatly appreciated. Thanks, MiMitch
The AC/Delco hubs have a seal pressed into the rear of the hub. I understand that some aftermarket hubs do not have this seal.
Thanks for all the help. My computer took a dump shortly after asking for info on my rear suspension proplem, so it took me awhile to respond. Thanks again to all that replied, MiMitch
Originally Posted by MiMitch
Punch in your year and model and go to suspention/steering.
The rear hub has a view button that shows an exploded view of all the parts.
Thanks for the help. I'll give it a try.
Originally Posted by wishuwerehere82
By wisheyehad1 in forum C6 General Discussion
Last Post: 08-20-05, 03:32 PM
By johnd in forum C3 Technical and Performance
Last Post: 07-22-03, 03:18 PM
By jeffs S/A in forum C3 Technical and Performance
Last Post: 12-10-02, 07:50 AM
By Scissors in forum C5 Technical and Performance
Last Post: 04-04-02, 07:45 PM
Owned and Operated by © 2000-2015 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved