C4 1984 change to bigger brakes
Hi Im restoring and preparing my C4 from 1984, and want to put bigger discs and brakes on it, is it possible to use newer discs on it, without doing mayor changes to the hubs and Suspension? I have the 17 inch rims, so have enough room for them already>
Originally Posted by victorgomez01
I did this mod when I had my 84. Used the C5 brake calipers and rotors in combination w repro 17" ZR-1 wheels. Was a great improvement.
The brakes along w swapping in a ZF-6 in place of the 4+3 trans really transformed the car for me. It was sooooo much more fun to drive. You can install the C5 brakes on the 84 spindle, but you'll need to open up the brake mounting bolt boss from 12 to 14mm.
Others have done this and have had no issue. I decided to use 87 spindles which are already built with the 14mm bolt boss.
By norvalwilhelm in forum C3 Technical and Performance
Last Post: 01-20-05, 01:34 PM
By KGV in forum C4 Technical and Performance
Last Post: 07-15-04, 06:46 AM
By rrubel in forum C4 Technical and Performance
Last Post: 08-17-02, 10:15 PM
Owned and Operated by © 2000-2015 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved