Stevie Ray Grigg
Can you hear the blend door moving at all when you change the temperature? Or airflow change in the ducting?
I'm not sure on the 95's but my 93 has either a manual cable operated blend door or a electric operated door. What is yours? Electronic Climate Control or Manual.
If it is vacuum controlled the blend door that is, it can be tested for proper operation with a vacuum pump.
If that is in proper working order, then I suspect inadequate coolant flow through the heater core. Might need flushed out, or if really bad replaced.
Just because the heater hoses are hot doesn't mean crap. I had my butt handed to me by a Taurus with lack of heat concern. The hoses where hot, but not quite hot enough. Blend door worked so, I flushed the heater core. Still didn't work correctly, car ran normally, turned out it needed a water pump, yes a water pump. The impeller was ate away. The cooling is good enough in Taurus 3.0L V6 engines that the natural laws of thermodynamics keep the coolant moving enough in the engine to keep it cool, but not enough to have heat in the cabin.
Gone but not forgotten
Vacuum Check Valve for Cruise and Heater
This is the Check valve that controls the vacuum to the heater and cruise. You should be able to pull or suck on one of the smaller connectors while holding a finger over the other small connector and there should not be any air come through the larger discharge fitting.
If this is bad get the OEM part I tried the auto store ones and they do not hold up and besides I think it was only about $10.00 for the OEM.
It's got so it seems to me that the Internet has created a lot more Horses A$$'s than we have Horses!
Founding Member: 10 Corvettes Anonymous
Gone but not forgotten
Call Me Backwards
Junk I could not remember what you told me about how to check the valve. Spent an hour looking at the FSM and no answer so I just guessed on which way it worked.
I have a new problem that I am going to post and hope you can give me some help.
That is exactly what I thought, that the mode doors where vacuum operated, my FSM shows blend door operation via manual cable or electric stepper motor.
Originally Posted by vetteoz
By JohnnyC in forum C4 Technical and Performance
Last Post: 06-10-08, 08:47 PM
By sscam69 in forum LT4 Forum
Last Post: 04-29-06, 04:06 PM
By Jack in forum C3 Technical and Performance
Last Post: 03-10-02, 08:36 AM
By JimS in forum C4 Technical and Performance
Last Post: 01-29-02, 07:32 PM
By white81 in forum C3 Technical and Performance
Last Post: 07-07-01, 12:36 PM
Owned and Operated by © 2000-2015 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved