Trunion replacement on outside mirror
Asked this on General Discussion no replies so Im posting it here
Does any body know how to replace the TRUNION for the mirror on the outside of the car, the TRUNION is the X looking piece to keep it from wobbling around
Thanx in advance
96 LT1 CE
I replaced mine a few years ago, bought them from Mid America. If I remember correctly, directions came with them. The mirrors just snapped out, careful tho, there are wires attached to them for the heaters. Pulled the old trunions off, put the new ones in and snapped the mirrors back into place.
Thanx Scott, will try this weekend when it gets below a 100 here in phoenix
My mirror was rattling for a long time, the trunion fix was on my to-do list. I finally pulled the mirror off one day and the mounting screws were loose, I just tightened them back up and no more rattle.
Yep one screw loose and one totally gone, all better now.
By gmhowe in forum C4 General Discussion
Last Post: 05-20-08, 05:27 PM
By muskiemike in forum C4 Technical and Performance
Last Post: 05-20-08, 10:47 AM
By Chris Kennedy in forum C4 Technical and Performance
Last Post: 01-02-07, 09:37 AM
By raaizin in forum C4 General Discussion
Last Post: 02-16-05, 08:28 PM
By 22229stingray81 in forum C3 Technical and Performance
Last Post: 11-20-04, 09:24 PM
Owned and Operated by © 2000-2015 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved