1990 ZR-1 Parts For Sale

**Rob** · 03-29-02, 10:42 PM

I should probably post this in the Generation Marketplace forum, but since the ZR-1 Forum doesn't see as much traffic as I'd like, maybe this thread will help give it a boost.

Anyway, the following is a list of 1990 ZR-1 parts that someone is selling and I told them I would post them here:

Here' s a list of parts 1990 zr1 parts (unless otherwise stated the
parts
have a little over 2,000 miles on them.)

Front end-less pads and rotors
front spring
front sway bar
set of shocks-18,000 miles
ZF6 transmission- 18,000 miles
Complete rear-disc to disc
Fuel sending unit
gas tank-unknown mileage
windshield wiper motor
AIR motor? thing that looks like a bell by the driver's side front
bumper
spare tire tray
stock exhaust
air conditioning hoses cooling pipes and hoses
four tail lights-used
clutch master cylinder
clutch slave cylinder
camshaft sensor
abs controller-havey piece that's behind the driver's side seat
plenum
coils
heads
ignition module-under the plenum
lt5 wires
stock cams
bell housing
dual mass flywheel
cats
starter
power steering pump
water pump
alternator
fuel injectors with rails
fuel injector housing-both sides
thermostat housing
stock crankshaft
engine block
oil baffle
also have other miscellaneous parts-such as some wiring harneses,
certain
modules, the a/c and heat control panel,seat belts, visors etc.

Neil
Email: neilfal@aol.com

**BiZ** · 04-02-02, 08:49 AM

I sent you an E-mail. And it now seems my water pump just took a dump. Let me know what you want for the parts I E-mailed you about. Especially the water pump.

Jason

**FrankUrbinati** · 04-04-02, 04:10 PM

I sent an E-mail about Alternator bracket's and a few other part's.

inferno-vette · 04-16-02, 02:18 AM

how much for the ZF-6 and the rear?

**1badzr1** · 04-24-02, 11:23 AM

Please email me privately on the cost of the wires I am interested in them. BRoberts2@exchange.ml.com

Regards,
BR

**FrankUrbinati** · 04-24-02, 03:09 PM

Has anyone got a response from this person ?

USA ZR1 · 04-30-02, 01:46 PM

I would be interested in the injector housings,Rob.

**Rob** · 04-30-02, 01:52 PM

Clint,

You'll have to contact Neil. He's not a member of the forums here. I just posted it for him. His email address is in the post at the top of this thread.

-Rob