hand brake on center console
The chrome retainer around the button on my hand brake is chipped. Does anyone know anything about replacing or repairing it? I don't want to spend $100 on a new handle just to replace the retainer.
I think the thing needs to be redesigned out of aluminum or something. Mine cracked about halfway down underneath and flexes badly every time I set it. I assume its due to the fact that thats where the metal part ends.
I saw a custom one in a pic by a guy in europe that was aluminum and pretty cool looking. Tried to get him to sell me one but he didn't want to share.
Know of any that won't break after a few years use?
By 69_Dream in forum C3 Technical and Performance
Last Post: 07-30-09, 10:56 AM
By Rob in forum Wheelspin
Last Post: 12-31-06, 11:07 AM
By mcditalia in forum C1 & C2 General and Technical Discussion
Last Post: 02-18-05, 08:23 AM
By cwerve74 in forum C3 Technical and Performance
Last Post: 09-29-03, 05:51 PM
By JohnnyD in forum C4 Technical and Performance
Last Post: 01-06-03, 08:11 AM
Owned and Operated by © 2000-2013 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved