Steering box adjustment
Besides the simple adjustment on top of the box has anyone loosened the lock ring where the steering shaft enters the box as well as the nut and done the play adjustment?
Can this be done with the box in the car and connected or do I have to pull it.
Thanks for any pointers/advice your can give.
I will be keeping an eye on this thread. I have heard this can be done, and even read about it in a repair manual. However, I am little uneasy messing around with the steering gear box.
I talked to Gary at VB&P about this. They don't suggest doing it at all. I have seen this process done on S-10 trucks with no problems at all.
By TWINRAY in forum C3 Technical and Performance
Last Post: 09-07-04, 09:57 AM
By topless82vette in forum C3 Technical and Performance
Last Post: 12-17-02, 03:59 PM
By Stallion in forum C3 Technical and Performance
Last Post: 12-10-02, 01:31 PM
By resto75 in forum C3 Technical and Performance
Last Post: 09-03-02, 02:10 PM
By 80convertible in forum C3 Technical and Performance
Last Post: 10-11-01, 04:01 PM
Owned and Operated by © 2000-2013 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved