wiper door limit switch, normally open or closed wiring ?
I have 12 volts at this switch and it is wired as a normally closed switch.this is confusing to me,I would think it should be normally open and held closed by the wiper door bracket arm.It is working in reverse right now.is this a matter of switching leads or is there a wiring problem somewhere else ? or should this just be a matter of getting a normally open switch.confused newbie needs help !!!!!!!!!!
This is from Wilcox's web site.
Hope it helps.
The assembly instruction manual (AIM) has a note stating the limit switch pigtail must mount to the inboard side of the bracket.
By anchors in forum C3 Technical and Performance
Last Post: 05-01-12, 11:39 AM
By Koop in forum C3 Technical and Performance
Last Post: 12-15-08, 10:17 AM
By Eddie 70 in forum C3 Parts For Sale / Wanted
Last Post: 02-15-05, 07:18 AM
By ernie d in forum C3 Technical and Performance
Last Post: 11-27-03, 09:47 AM
Owned and Operated by © 2000-2013 Corvette Action Center | |
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division. Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©. Copyright/trademark/sales mark infringements are not intended, or implied. All Rights Reserved