Corvette Action Center - The ultimate online hub of Corvette news and information! Click here to go to to the 2014 C7 Corvette Center

Supporting Vendors / Dealers - Supporting Membership - Advertising Information
Results 1 to 5 of 5

Thread: Cowl upper vent door replacement

  1. #1
    Member teedawg's Avatar
    Join Date
    May 2005
    Location
    Piedmont, SC
    Posts
    18
    Corvette(s)
    1969 Black & Gold Coupe

    Default Cowl upper vent door replacement

    I need to replace the cowl upper vent door on my '69 a/c coupe. Does anyone know how do this? It located right in front of the blower and below the wipers. It closes off the fresh air when the max a/c is on. Any help is appreciated!!!!

  2. #2
    Member 6880 Mike's Avatar
    Join Date
    Jun 2006
    Location
    The Bluegrass State
    Posts
    2,490
    Corvette(s)
    1968 convertible; 1980 L-82

    Default

    The assembly instruction manual (AIM) shows the installation. The door and frame were installed on the cowl before the front clip was bonded on. For some model years, the door mounts from the engine compartment side, for other years, they mount from the backside.

    Finding a replacement door in good condition could prove to be a problem.

    Good luck.


  3. #3
    Member teedawg's Avatar
    Join Date
    May 2005
    Location
    Piedmont, SC
    Posts
    18
    Corvette(s)
    1969 Black & Gold Coupe

    Default

    I found a repop from zip. i will look through the manual again. i havent seen anything other than how it's mounted to the firewall. i was hoping for something other than front clip removal. thanks.

  4. #4
    Member 6880 Mike's Avatar
    Join Date
    Jun 2006
    Location
    The Bluegrass State
    Posts
    2,490
    Corvette(s)
    1968 convertible; 1980 L-82

    Default

    Quote Originally Posted by teedawg View Post
    I found a repop from zip. i will look through the manual again. i havent seen anything other than how it's mounted to the firewall. i was hoping for something other than front clip removal. thanks.
    It's in the Options Section of the AIM; C60 air conditioning. Only factory AC cars got the door. The door screws into a tapping plate.

    This might help even though the front clip is off of this car. This one looks like it mounts from the engine side.




  5. #5
    Member teedawg's Avatar
    Join Date
    May 2005
    Location
    Piedmont, SC
    Posts
    18
    Corvette(s)
    1969 Black & Gold Coupe

    Default

    thanks. i have no idea how i'm going to replace it.

Similar Threads

  1. cowl vent lever mounting area
    By CHEV66JB in forum C1 & C2 General and Technical Discussion
    Replies: 1
    Last Post: 01-14-07, 08:01 AM
  2. C1 Cowl vent
    By IH2LOSE in forum C1 & C2 General and Technical Discussion
    Replies: 9
    Last Post: 10-22-04, 12:20 PM
  3. Wanted: 58 cowl vent.
    By 58n65 in forum C1/C2 Parts For Sale / Wanted
    Replies: 1
    Last Post: 05-09-04, 06:12 AM
  4. How to remove cowl vent screen?
    By fhturner in forum C5 Technical and Performance
    Replies: 0
    Last Post: 07-24-03, 10:51 PM
  5. Cowl induction vent
    By GW74 in forum C3 Technical and Performance
    Replies: 5
    Last Post: 07-08-02, 05:54 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© CORVETTE is a registered trademark of the General Motors Corporation & Chevrolet Motor Division.  Neither Chevrolet Motor Division nor any subsidiaries of GM© shall bear any responsibility for CorvetteActionCenter.com content, comments, or advertising. CorvetteActionCenter.com is independent from GM© and is not affiliated with, sponsored or supported by GM©.  Copyright/trademark/sales mark infringements are not intended, or implied.  All Rights Reserved