Did I Screw up the Rear Spindle Bearing Housing?

Wilkinshc · 10-09-05, 09:50 PM

I disassembled the rear trailing arms and I dropped the bearing housing. Is it ruined?

Thanks
Chuck

Stingray6974 · 10-09-05, 10:02 PM

Nope. All you did was bend the dust shield which needs to be replaced when changing bearings. I have them in stock.
Mike

Wilkinshc · 10-09-05, 11:08 PM

Thanks for the reply, I thought it might be the seal but I didn't see a seem. Must be the years of crude.

I checked your site out, I will keep you in mind it the future. I plan on sending these out to Tom's Differential, I plan on using his offset trailing arms with upper control arms, 35 spline spindles, and 1480 u-joints.

Thanks again.
Chuck